Vogelzang International Shiloh TR002 Owner's Operation And Instruction Manual

THIS APPLIANCE REQUIRES A SOURCE OF COMBUSTION AIR. IF YOUR HOME IS OF TIGHT CONSTRUCTION OR HAS NEGATIVE PRESSURE PROBLEMS, YOU WILL NEED AN OUTSIDE SOURCE OF AIR. BELOW IS A LIST OF POSSIBLE INDICATORS THAT A SOURCE OF OUTSIDE COMBUSTION AIR MAY BE REQUIRED. 1. Mobile home installations - Required 2. Your stove does not draw steadily, smoke rollout occurs, wood burns poorly, or back-drafts occur whether or not there is combustion present. 3. Existing fuel-fi red equipment in the house, such as fi replaces or other heating appliances, smell, do not ope ...

A wood stove must never be installed in a hallway or near a staircase, since it may block the way in case of fi re or fail to respect required clearances. It is of utmost importance that the clearances to combustible materials be strictly adhered to during installation of the stove. Refer to the tables below : • Do not place any combustible material within 4’ (1.2m) of the front of the unit. • The clearance between the fl ue pipe and a wall are valid only for vertical walls and for vertical fl ue pipe. • The chimney connector must not pass through a ...

4 2 40292A 6" Flue Collar 1 3 69354 Blower Assembly (B36) 1 4 83045A Washer, 3/8"Id X 7/8" Od X 1/16 Th k 3 5 83172 #10Ax1/2 Hx W Sm Scr Bl Ox 99723 8 6 83431 Weld Tab 3 7 83432 5/16-18 X 1-1/2 Hx Hd C/S Pl 3 8 88042 1/4" Rope Gasket 1 9 89066 Firebrick (4-1/2 X 9) 4 10 891414 Half Firebrick 4 11 891800 Main Weldment 1 12 891824 Heatshield Weldment 1 13 891095 Firebrick (1-1/4 X 6 X 8-1/4) 3 14 892291 Top Trim 1 15 892292 Hearth Trim 1 16 83343 #10X1/2 Hx Hd Dp Ox Black 6 Key Part No. Description Qty 17 83595 Shoulder Bolt ...

Your chimney connector and chimney must have the same diameter as the stove outlet (6”). If this is not the case, we recommend you contact your dealer in order to insure there will be no problem with the draft. The stove pipe must be made of aluminized or cold roll steel with a minimum thickness of 0.021” or 0.53 mm. It is strictly forbidden to use galvanized steel. Your smoke pipe should be assembled in such a way that the male section (crimped end) of the pipe faces down. Attach each of the sections to one another with three equidistant metal screws. Seal ...

value is when water leaves the combustion process as a vapor, in the case of woodstoves the moisture in the wood being burned leaves the stove as a vapor. The higher heating value is when water leaves the combustion process completely condensed. In the case of woodstoves this would assume the exhaust gases are room temperature when leaving the system, and therefore calculations using this heating value consider the heat going up the chimney as lost ...

of the stove every time it is emptied, in order to insure that no parts have been damaged, in which case repairs must be performed immediately. Inspect and clean the chimney and connector pipe periodically for creosote buildup or obstructions. AIR TUBES The air tubes assembled in this unit are designed to provide an accurate mix of secondary air to insure the highest effi ciency. Any damage or deterioration of these tubes may reduce the effi ciency of co ...

a few seconds prior to opening the stove’s door. Then proceed by opening the door very slowly; open it one or two inches for 5 to 10 seconds, before opening it completely to increase the draft and thus eliminate the smoke which is stagnant in a state of slow combustion in the stove. Then bring the red embers to the front of the stove and reload the unit. For optimal operation of your wood stove, we recommend you to operate it with a wood load approximatel ...