VISIONARY DESIGNS MOD-9002 Quick Start Manual

2) Slide assembled header frame, over connector, on top of post. 3) Attach graphic to clamps. See A10 Clamp detail. Bolt Base Plate Z-Plate Graphic Post Header Frame Connector Header Frame Assembly 1) Attach frame pieces together, as shown, with graphic infill between. 2) Attach vertical to bottom of assembled frame. 12.52” extrusion 12.52” extrusion 15” extrusion 10” extrusion 15” extrusion Graphic Infill Header frame stays assembled, when packing. Slide header frame, over connector, on top of Z-plate. Connector Z-Plate Header Frame A10 Clamp Tighten knob to secure graphic into clamps. Keep connectors, clamps, and Z-plate attached to post, when packing. MOD-9002 Hand Sanitizer Stand with Graphic If you would like to tell us about your experience with your setup instructions please email us at [email protected] SETUP INSTRUCTIONS

DO NOT USE SCREWS THAT ARE STRIPPED ALL CONNECTIONS MUST BE TIGHTLY SECURED General Setup Instructions - Read entire setup instruction manual prior to unpacking parts and pieces. - The setup instructions are created specifically for this configuration. - Setup instructions are laid out sequentially in steps, including exploded views with detailed explanation for assembly. WARNING Cleaning & Packing - For Cleaning Metal, Plex, & Laminate Parts: Use a MILD NON-ABRASIVE cleanser and soft cloth/paper towel to clean all surfaces. - Keep exhibit components away from heat and prolonged sun exposure. Heat and UV exposure will warp and fade components. - Retain all provided Packing Materials. All provided packing materials are for ease of repacking & component protection. Disassembly - For loss prevention, tighten all set screws and locks during disassembly. Hex Tool - Essential for Assembly General Information