Viking CVDR5606GO Installation Manual

2 1 x2 3 1 2 4 1 Remove two screws from back of range. Attach bracket to back of range using two screws. 1 A Ø 1/8” Ø 1/8” (.32 cm) (.32 cm) Ø 1/8” (.32 cm) 1-1/4” + B* 1-1/4” + B* 1-1/4” + B* Locate anti-tip bracket hook on the floor Dim A from side cabinet and 1- 1/4” (3.2 cm) from rear wall when using an island trim or high shelf. If using an 8” (20.3 cm) backguard, add Dim B to the 1-1/4”. Mark and drill 1/8” (.32 cm) holes where bracket will be located. A B *(Add only when using 8” backguard) 30” 12-3/4 ...

Dimensions ________________________________________________________________________6 Specifications ______________________________________________________________________8 Clearance Dimensions (Proximity to Cabinet __________________________________________10 Clearance Dimensions (Wood/Composite Overlay) ____________________________________11 Electrical & Gas Requirements ______________________________________________________12 General Information__________________________________________________________ ...

2 3 4 Open door completely. Fold latches backward until locked in place. Slowly close until latches stop door. Lift door up and out. Door Removal ...

This product is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, ANSI/NFPA 70-latest edition (See Rating chart below). If local codes prohibit grounding through the neutral, use a 4-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, ANSI/NFPA 70-latest edition (See Rating chart below). RATING* Specified Rating of Power Supply Cord Kit and Circuit Protection 120/240 Volts ...

Slide range into place. Be sure wall anit-tip bracket slides into the anit-tip opening and floor anti-tip hook and bracket are engaged. Final Installation DANGER FIRE HAZARD Backguards come standard with standoff spacers which provide a barrier between back of range and rear wall. These must be in place for adequate ventilation. Standoff spacers can only be removed if range is installed against a Non-Combustible wall. Standoff Spacer Removal Installation 2 s t e p Make sure rear trim is properly installed. 1 s t e p Connect gas and electrical. Before placing appliance in operation ...

CSA. Clearances to non-combustible materials must be approved by the authority having jurisdiction. C/VDR548 C/VDR560 Overall width 47-7/8” (121.6 cm) 60” (152.4 cm) Overall height To top of side trim –35-7/8” (91.1 cm) min. 37” (94.0 cm) max. Legs adjust – 1-1/8” (2.8 cm) Overall depth from rear* To end of side panel - 24-5/16” (61.8 cm) To front of door - 25-3/4” (65.4 cm) To end of door handle - 28-11/16” (72.9 cm) Additions to Base Height To top of ...

to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, a qualified licensed plumber, or certified gas installer. 14 READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. • All openings in the wall behind the appliance and in the floor under the appliance must be sealed. • DO NOT obstruct the flow of combustion and ventilation air. Moving, Handling, and Unpacking Remove and discard all p ...