Ei Electronics Ei2110 User Instructions
Text of the manual
Contains vital information on unit operation and installation. Read and retain carefully.
If you are just installing this unit this leaflet MUST be given to the householder.
MULTI-SENSOR FIRE ALARM
with Rechargeable Lithium Cell Back-up
230V~
B16351-R0-Ei2100 SERIES-USE.qxd 18/9/08 3:47 PM Page 1
1. REGULAR CHECKS
2. ALARM REMOVAL
3. IMPORTANT INFORMATION
4. MULTI-SENSOR FIRE ALARM FEATURES
5. TESTING & MAINTAINING YOUR ALARM
5.1 IF YOUR UNIT IS BEEPING
6. CLEANING YOUR ALARM
7. NUISANCE ALARMS
8. ALARM MEMORY
9. IMPORTANT SAFEGUARDS
10. PLANNING YOUR ESCAPE ROUTE
11. ALARM CONTROL
12. GETTING YOUR ALARM S
1. REGULAR CHECKS
Look for:
Constant green light
Red light flash every 40 sec.
Press test button for 10 sec.
Alarm will sound loudly.
Vacuum around
side vents to clean.
B16351-R0-Ei2100 SERIES-USE.qxd 18/9/08 3:47 PM Page 3
2. ALARM REMOVAL
LOCATE REMOVAL SLOT
LOCATE THE ARROW ON THE FRONT FACE OF THE ALARM.
THE SLOT IS LOCATED DIRECTLY ABOVE THE ARROW.
INSERT SCREWDRIVER
INSERT A FLAT-BLADED SCREWDRIVER HORIZONTALLY
ABOUT 10mm INTO THE CENTRE OF THE REMOVAL SLOT
SLIDE ALARM OFF BASE
WITH THE SCREWDRIVER STILL INSERTED, PUSH THE LOWER
HALF OF THE ALARM AWAY FROM THE SCREWDRIV
3. IMPORTANT INFORMATION
Do not paint your alarm. Do not allow paint, water or dust
to contaminate your alarm.
Your alarm is a mains 230V AC electrical appliance. Do not
open or insert anything into the alarm.
Regularly check that the green mains indicator light on the
cover is on.
If the alarm beeps and the red light flashes at the same
time the battery i
