Servomex 2700 Installation Manual

02700005D_7 • Where necessary fit the weld-on flange or adaptor flanges as described in Sections 3.2.2 and 3.2.3. • Mount the high temperature stand-off [3] onto the flue using a 4" ANSI sealing gasket [2]. If a 4" ANSI weld-on, or adaptor flange, is already fitted then screw in four of the M16x55mm studs [9] into alternate holes in the weld-on or adaptor flange [1] and attach the high temperature stand-off through the four plain holes in the stand-off flange. If the high temperature stand-off is to be attached to an existing 4" ANSI flange then use four ...

02700005D_7 12 Appendix D – REACH Regulation In pursuance of the requirements included in Article 33 of the European REACH Regulation on the Registration, Evaluation, Authorisation and Restriction of Chemicals, information on Substances of Very High Concern (SVHC) contained in Servomex products is provided on www.servomex.com. ...

02700005D_7 1 Terminal block TB5 (combustibles sensor wiring) Pin 1 at right-hand side 5 Terminal block TB1 (main power wiring) 2 Stud terminal - S 6 Plastic safety cover 3 Terminal block TB3 (oxygen and sensor head temperature wiring) Pin 1 at right-hand side 7 Terminal block TB9 (mains voltage selection (Pin 1 at right-hand side 4 Fuse F1 8 External earth terminal CAUTION After installation, the Sensor Head should not be left on the flue unpowered for extended periods, as condensation may form within the sample pipe work. The Sensor Head should be removed f ...

55 • To comply with the relevant safety requirements the cables carrying mains power and connected to the control unit shall be approved to: o IEC 60227 or IEC 60245, and be designated H05VV-F for equipment used in the EU o UL 817 or CSA C22.2 No. 21, and be designated STO for equipment used in North America. • Gland entry sizes and positions are shown in Figure 18. Unused entries should be fitted with appropriate blanking plugs. • All control unit cable glands and blanking plugs shall either be made of metal or have a flammability rating of V- ...