RUKO U11 Quick Start Manual

Self-equipped 1 Charge the Batteries 15W RUKO GPS Download App RUKO GPS App RUKO GPS Download on the App Store Download for Android

remote controller plays a "beep" sound. Remove the sponge sheet, then install the battery. Press and hold the button until the Aircraft plays startup sound. Push the button to power on the Transmitter. 5 Pair the Transmitter with the Aircraft Copyright ©2021 Ruko All Rights Reserved. 5 Once successfully paired, only red light will stay on and blue light is flashing. 2 3 1

the controller plays a "beep" sound. ( About 3 turns) Rotate the aircraft vertically 360° the controller plays a "beep" sound . ( About 3 turns) 6 Calibrate the Compass Connect to Wi-Fi Copyright ©2021 Ruko All Rights Reserved. 6 Connect the mobile device to the Aircraft's Wi-Fi and enter the App operation page. Tap "Go Flying" icon drone-****** Go Flying

Copyright ©2021 Ruko All Rights Reserved. 7 Push the right stick to 5 o'clock position until the controller plays a "beep" sound. ( About 2 seconds ) Push up the left joysticks. Start the Motors Push joysticks to 5 & 7 o'clock position. ( About 2 seconds ) A level ground

[email protected] +1 ( 949 ) 394 - 4635 ( Available from 6pm to 3am PDT) Printed in China. Search “Ruko U11 Quick Start” on YouTube for First Flight Copyright ©2021 Ruko All Rights Reserved. 8 NEW TO FLYING DRONES? Scan QR Code for More Tech and Video Support Check the Flight Guide in the App 1 2 Go Flying

Common Problems and Solutions The gyroscope is not calibrated Question Reason Solutions The motors cannot be started The Transmitter signal is interfered or the Aircraft exceeds the range of remote control Wait until GPS signal is found before taking off Follow the correct corresponding markings to install blades Please fly the Aircraft outdoors without interference, and ensure that it is within a controllable range Please manually land the drone in time and calibrate the compass. Please make sure to fly away from the buildings, trees, power lines, and signal towers Can't fly high after flying to 4 meters Can't take off after replacing the blades Out of control, spinning around on its own, abnormal sound Pictures and videos can't be saved in SD card Only photos and no videos are saved on the mobile phone Replace the propellers with new ones Please fly the Aircraft in an open area free of obstacles within the circle of radius 32.81 ft(10 meters) The propellers become deformed and incomplete GPS signal is unstable. Flying near buildings and in obstructed places It can only fly 4 meters high in optical flow mode The GPS signal is not found when flying outdoors 4 blades are installed reversely or 1 blade is installed wrong Compass interference The propellers become deformed and incomplete The SD card is full The storage file format is not set correctly Problem of SD card This is the unique design of the camera, not a malfunction After the SD card is installed, the mobile phone does not store video, which is stored on the card Replace the propellers with new ones Delete the contents of the SD card Select the FAT32 file format when formatting Try to format or replace the SD card Turn on the Aircraft in an open area with strong GPS signal The Aircraft has low battery. Please charge the battery in time Push the left and right joysticks simultaneously to 5 o’ clock and 7 o’ clock for 2 seconds Weak GPS signal The red light stays on The left and right joystick are not in place Please fly the Aircraft above 9.84ft(3 meters) Place the Aircraft on a horizontal surface and conduct gyroscope/horizontal calibration. Please refer to the "Calibration Before Flight" section of the user manual Unstable flight Flying too low, affected by airflow

transmission distance is short App does not display the interface The WiFi name is not displayed in the list GPS signal is weak Unable to return home, drifting and flying away The Transmitter does not charge / App always says the Transmitter has low battery The Aircraft cannot be paired with the Transmitter Phone cannot connect to Wi-Fi The Aircraft is out of Wi-Fi range WiFi image transmission signal interference The transmitter and the mobile phone are not pointed at the direction of the drone Phone performance freezes The phone is not connected to Wi-Fi The phone version is too low When connecting to the drone’ s WiFi, the network is not set or set incorrectly VPN switch is turned on It is the first time to connect your phone to the Wi-Fi The phone is a single band phone WiFi has not been activated Turning on the drone indoors Under the tree, next to the building, in an obstructed place GPS signal was turned off during the flight The phone cannot connect to the Transmitter due to the wrong sequence for turning equipment on Pairing the Transmitter with the Aircraft without unlocking the Transmitter The correct sequence is: Turn the Aircraft on first,then turn on the Transmitter.Next push the left stick down to pair the Transmitter with the Aircraft. Connect your mobile device to Wi-Fi in the end Correct pairing steps: 1. Turn on the Aircraft. 2. Turn on the Transmitter: push the left joystick down to 6 o'clock position to unlock the Transmitter and pair it with the Aircraft. Use the dual band devices that support both 2.4 GHz and 5 GHz/5.8 GHz Wait for about 30 seconds after turning on the Aircraft and keep refreshing the Wi-Fi list while the Wi-Fi is activated GPS signals cannot be found indoors, please search for GPS signals in an open place outdoors Please stay away from obstacles for more than 32.81 feet(10 meters), and search for GPS signals in an open area Please don't turn off GPS suddenly during outdoor flight. Switch back to GPS mode in time Point the Transmitter and the mobile device at the flying direction of the Aircraft to maintain the strongest signal connection Close unused apps running in the background to maintain the best performance of the phone Connect your mobile device to the Wi-Fi : drone-***** Android 6.0 and above, IOS 10.02 and above Set the Wi-Fi correctly Turn the phone to airplane mode Turn off the VPN switch Try connecting a few more times or restart the phone Fly the Aircraft within the range of the Wi-Fi Fly the Aircraft in an unobstructed open area free of buildings, high-voltage wires and signal towers Copyright ©2021 Ruko All Rights Reserved. 10 Question Reason Solutions

Cannot charge battery/Cannot fully charge battery Short battery life The product has slight marks Using inferior charger or charging on the computer with unstable voltage output Using inferior charging cables Flying in windy weather Flying in cold weather The battery is not fully charged We tested all Aircraft before shipping Please use the original factory charging cable to charge Flying in windy weather will accelerate power loss In low temperatures, the chemical reaction of the lithium battery is slowed down and the energy cannot be fully released Please use the correct charger to fully charge In order to give you the best experience, we tested functions of all Aircraft before shipping. Therefore, it is inevitable that there will be slight traces. However, it can be guaranteed that all Aircraft are 100% brand new Use a mobile USB charger that ensures constant stable voltage output(5V) and amperage output(2-3A) Question Reason Solutions