Toshiba NV Series Operation & User’s Manual

25 (2) Healthy counter Indicates the normal operating status of the PF module. Table 5-3 Healthy counter F E D C B A 9 8 7 6 5 4 3 2 1 0 0001h Healthy Counter Indicates that the PF module is operating normally. A 16-bit counter that is updated every 100 ms. Returns to 0 after FFFFh. (3) Device error Indicates the transmission module error status. Table 5-4 Device error F E D C B A 9 8 7 6 5 4 3 2 1 0 0002h Device Error The error status is indicated with the following codes: Error No. Description 0 No er ...

Warning Do not touch any terminal of the module and unit during energization. Otherwise, electric shock may be caused. Do not modify / repair / disassemble / adjust the device, module, or board. It may cause electric shock, fire, injury, or failure. Upon malfunction or failure, contact our branch offices or service offices. Before using, check that the power capacity, frequency, voltage, and regulation comply with the device specifications. If not, it may cause not only insufficient performance, but also damage of the device or fire due to overhea ...

7 Figure 2-2 Appearance of PF612A module ...

51 C.3 Registering and Assigning Network Variables Assign the controller interface DPRAM data of the PF611A and PF612A module to system network variables. This enables the user program on the type1 light controller to handle the cyclic data communicated by cyclic transmission on the PROFIBUS-DP as network variables. In addition, the data transfer between the module DPRAM and network variable is performed collectively by the type1 light controller OS at the beginning of the sequence. The case for PF611A ...

PROFIBUS-DP Module PF611A / PF612A User’s Manual Dec. 2021 2nd Edition Industrial Systems Division 72-34, Horikawa-cho, Saiwai-ku, Kawasaki 212-8585, Japan © Toshiba Infrastructure Systems & Solutions Corporation. 2021 All Rights Reserved. No part of this document may be reproduced without permission. ...

(Engineering Tool Ver.4) C.1 Registering the Module .......................................................... 48 C.2 Registering the LAN ............................................................... 50 C.3 Registering and Assigning Network Variables ....................... 51 ...

6F8C1872 52 Network Variable Registration Open the Network Variable edit screen from the Talker Block edit screen and register the network variable name for each Talker Block. (17) Click the [Open Network] button on the Talker Block edit screen to open the Network Variable edit screen. (18) Unlock the [Lock up]. (19) Register network variables to Talker Blocks in the upper half of the Network Variables edit screen. Talker Blocks can be selected from the [Talker Block] pull-down menu. (20) Register the network variable as inpu ...