Toshiba NV Series Instruction Manual

6F8C1566 80 The following figure shows the outside dimensions of the EN655. Figure B-1 EN655 outside dimensions ...

the product and does not guarantee or grant the license of the intellectual property rights or other rights of our company or third parties. (2) No part of the contents of this manual may be reproduced without permission from TOSHIBA Corporation. (3) The contents of this manual are subject to change without notice. (4) All possible measures have been taken to prepare the information herein. If you have any question or find any error or problems, please contact us. PROSEC ...

Unified Controller nv series Ethernet Module (EN655) Instruction Manual 77 A.2 Ethernet Transmission Specifications Table A-3 Ethernet transmission specifications Item Specification Interface 100BASE-TX/10BASE-T Network system Electrical Topology Star(HUB Connect) Transmission speed 10Mbps/100Mbps Transmission cable UTP cable(CAT 5 or more) Connector form RJ-45 module connector Cable length Max. 100m Number of connection nodes Max.254 nodes(Max. 4 nodes/Controller) Communication service computer link connection, PC link, socket communication ...

Unified�Controller�nv�series�Ethernet�Module�(EN655)�Instruction�Manual� 31 ４ From the engineering tool’s product tree, select the EN655 module and click on . The System Log will then be displayed. Or you may also right click on the EN655 module and select System Log. Figure 3-15 Opening the MIB information ...

6F8C1566 38 The switches of the product have been adjusted for the system at the site adjustment. For normal operation, do not change any switch settings other than the ones the customer needs to operate. CAUTION Avoid incorrect setting. The product does not operate normally if the switches are set incorrectly. Read this instruction manual thoroughly to avoid incorrect setting. Prohibited CAUTION Stop using immediately when an error occurs. When an error occurs such as unable to turn on the power, stop using and contact one of Toshiba's service representatives. Mandatory ...

6F8C1566 42 Select the system station to be displayed from the engineering tool’s product tree. Run in the engineering tool menu to start System View. Figure 5-3 System View Screen Double click the “Alarm Status” marked red in fig. 5-3. The screen will be displayed as below. Figure 5-4 I/O Bus State Screen Figure 5-4 I/O Bus Status Screen ...

vii This manual describes the functions, methods of installation and setting, and maintenance and inspection of the Ethernet (EN655) module ("EN655 module" hereafter) for connecting the Ethernet to the Unified Controller nv Series. To use the devices correctly and safely, read "Safety Precautions" before use. After reading this manual, keep it in a safe place so that you can read it whenever necessary. Repairs and replacements due to depletion or wear are offered at cost even within the warranty period of this product. The ...