rockymounts RM031 Manuallines
Read Online
Read the rockymounts RM031 Manuallines online using the built-in PDF viewer.
Text of the manual
Ensure hardware is secure before use.
•
Periodically check hardware during use.
•
Only use kit as intended.
Parts Included
1
1
A - Attach the Bike carrier to car.
B - Loosen all 4 bolts on outside wheel tray. Then
remove the top two.
A
Plate Direct Mount Kit.
Features:
1- Plate bracket A (right).
2 - Plate bracket B (left).
3 - Plate bracket C (x2)
4 - R clip (x1)
5 - M8 flat washer (x12)
6 - M8 nyloc nut (x4)
7 - M8 x 20mm button head screw (x6)
8 - M8 spring washer (x2)
NOTE: For use with auxiliary plates only.
2
2
Position wheel tray so its threads are centred
withing the corresponding slots.
•
Check vehicle suitability with LED auxillary lights.
NOTE: Some vehicles may require resistors. Direct Mount Kit is available
for Rockymounts bike carriers.
3
4
5
6
7
8
B
=
=
=
=
Using M8x20mm button head screws with
spring and flat washers, fit bracket A and B.
4
Fit bracket C with 3x M8 flat washers, an M8 x
20mm button head screw and a nyloc nut.
3
Position LED light board over brackets and fit
with M8x20mm dome head screws, 2x flat
washers and a nyloc nut.
4
Using the M5 screws and flange nuts provided,
attach the license plate.
Tilt the license plate downward to face behind the
vehicle.
Lock the license plate in position using the r-clip
provided.
6
Wrap the excess cable (from LED light board),
around the carrier spine. Plug the 7 pin socket into
the connection at the rear of the vehicle.
Note, If using the bike carrier in a lowered position, always be sure to reposition the license plate holder as shown. Re-fix plate
in place with the r-clip.
