PEUGEOT e-208 2022 Quick Start Manual

Tyre pressure: see sticker on the pillar of the driver’s door Vehicle instruction manual: in the glove compartment. Before starting your journey Step 1 Check the vehicle for new damages, open the car using your cambio- or MOBIB- card or the cambioApp and follow the instructions on the onboard terminal. Step 2 Disconnect the charging cable correctly 1. Scan the charging pass (located in the driver’s side door) at the charging station to end the charging session. 2. Disconnect the charging cable from the vehicle (by pulling). The charge indicator (4) turns green. 3. Close both charging port covers (inner and outer covers) and place the charging cable in the boot of the vehicle PEUGEOT e-208 Caution: is the cable stuck because you waited too long? Lock the vehicle using the key and unlock it again – the cable should no longer be locked now. 1

Step 1 Stopping and correctly closing the car Press the START/STOP button. Check the following before getting out of the car. • the gear stick must be in the “P” position (press the P-button. • The “READY” light must be off. Step 2 Correctly connecting the charging cable Check if the gear stick is in the “P” position and if the ignition of the vehicle is turned off before charging. If not, charging won’t be possible. • Take the charging cable from the boot of the vehicle and connect it to the charging station. • Register at the charging station with the carging pass (in the driver’s side door). Press the charging port cover to open it and put the charging cable in place. The vehicle is charging correctly if the charging light blinks green in the charging port. You will also see the remaining time on the dashboard. 1. 2. 3. If this isn’t the case, the charging hasn’t started correctly. Follow the procedure again and check if the charging cable is plugged in correctly. A red light in the charging port indicates that the charging cable is locked in place. Put the charging pass back in the driver’s side door and close the vehicle (after putting the key back in the onboard terminal) using your cambio- or MOBIB-card or cambioApp Always check if the car is charging before leaving! The light in the charging port or on the dashboard (time until charging is complete) will indicate if the vehicle is charging. If the driver's door is opened while the required conditions for stopping are not met, an audible signal is emitted. Green = available Blue = charging Red = error LED lights on terminal 1. Place the key in the central console or hold it to the left of the steering column when the car doesn’t detect the key. 2. Place your right foot on the brake pedal for the following actions: - Press the “START/STOP” button briefly. - Keep your foot on the brake pedal until the full dashboard and all gauges light up. - Press the “UNLOCK” button (B) and select the “D/B” (forward) or “R” (reserve) position – (see indication light at C). 3.The electronic parking break will release automatically when you give gas. You can also release it manually by pressing the (P) button 4 Release the brake pedal gradually and slowly press the accelerator pedal. Step 3 Start the vehicle 2

braking and allows the car to slow down without having to press the brake pedal. The car slows down faster if you let go of the accelerator. When the accelerator is released, mechanical energy is recovered and the battery is partially recharged. Pushing the gear stick backwards in position D/B activates/deactivates the function. The status of the function is not saved when the ignition is turned off. D vs B position Eco mode The ECO mode is a function that optimizes the range of the vehicle, but does have an impact on its speed, acceleration, heating, etc. (De)activate the Eco mode using the “Drive mode” button on the central console Reverse gear Press and hold the “UNLOCK” button (B) while pushing the gear stick forward to switch to position R (reverse). The controls are on the driver's door: A Select left or right mirror B You can then adjust the mirror in all directions. Please move the switch back to its neutral position after adjusting. Adjust side mirrors Airco/heating Select . To adjust, use the Airco Menu on the touch screen. P R N D B Park Reverse Neutral Drive (forward) Brake (driving forward with regenerative braking) 3 Cruise control Use the controls on the steering wheel’s left side: 1. Select cruise control mode 2. Reduce set speed 3. Increase set speed 4. Activate/deactivate cruise control 5. Pause cruise control Braking disables the cruise control. The cruise control settings are displayed on the dashboard. See car manual for detailed instructions.

a tow hook are stored under the trunk floor. The vehicle makes a weak noise when driving less than 30km/h, both when driving forward and reversing. Electric vehicles are very silent, this system is a security measure to alert pedestrians and cyclists to your presence Pedestrian horn Lichten/Mistlichten Rotate the dial at the end of the lever left of the steering wheel to select the correct setting. Rotate the dial forward two clicks to switch on the rear fog lights. A second control light appears on the dashboard. Front wipers Push the lever right of the steering wheel upward to select either of the following modes: Fast wiping (heavy rain) Normal wiping (moderate rain) Intermittent wiping Single wipe Automatic wiping (the wipers turn on automati- cally when it rains). To switch off automatic wiping mode, push the lever upward and return to setting 0. Switching off Rear wipers Rotate the dial forward one click to operate the rear wipers (intermittent). Rotate the dial further forward to spray and wipe. Headlights Fog lights 4