Perle IDS-710 Hardware Installation Manual

Managed Industrial Ethernet Switches Updated: December 2020 Version: A.15.12.2020 Document Part# 5500471-10 www.perle.com ...

THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS GUIDE ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS GUIDE ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATI ...

Preface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Preface Audience This guide is for the network or computer technician responsible for installing Perle IDS Switch. Familiarity with the concepts and terminology of Ethernet and local area networks is required. Purpose This document describes the hardware and physical characteristics of the Perle IDS Switch. It covers har ...

Overview This chapter discusses the following topics: Switch Models Views LED Indicators Ports Port Status Indicators Terminal Block Connectors Installation The table below gives a brief overview of the models covered in this guide. For more details and for the most up-to-date list of models, please refer to the product ...

Switch Models Views IDS-710 (including XT models) LED Indicators PWR (Power Inputs) 1 – Reset / FS (Fast Setup) 6 – SFP slots 2 – Status LEDs 7 – 10/100/1000Base-T Ethernet Ports with PoE/PoE+/PoE++ capability 3 – Terminal Block for Digital Input and Relay 8 – Ethernet LED 1 4 – SFP status LEDs 9 – Ether ...

Sys (System Status) Alr (Alarm) Ports 10/100/1000Base-T Ports These ports provide the standard 10/100/1000 Mb/s Ethernet through twisted pair (UTP) cables of up to 100 meters (328ft) in length. SFP Slots The SFP slots can accommodate industry standard SFPs from Perle or other suppliers. These SFPs can be fiber or copper. ...

Power Connector The power input connector has provisions for dual inputs. Two independent power sources can be used to power the switch. If one power input fails, the other power input will power the switch. See - Terminal Block Connectors Alarm Relay Connector The Alarm Relay can be energized by the software or hardware ...

SFP Status LEDs Each SFP has a corresponding LED to indicate the current state of the fiber link. State Description Green Fiber link established Green flashing Link/activity Off No Link ...

Terminal Block Connectors P1(+/-) — Power Input 1. P2 (+/-) — Power Input 2. Either P1 or P2 can power the unit. When both are connected, one will act as a backup. IN(+/-) — Digital Input. Dry Contact. Relay — Normally Open (NO) relay. ...