peplink PEPWAVE FlexModule Mini Operation & User’s Manual

For Balance 20X / 380X / 580X Sep 2021 Important Notes 1. Please handle the connectors with care as to not damage them. 2. LTE-A (CAT-6) and LTE-A Pro (CAT-12) FlexModule Minis have 2x cellular antenna connectors while LTE-A Pro (CAT-18) and 5G have 4x cellular antenna connectors. So if you are upgrading from LTE-A (CAT-6) or LTE-A Pro (CAT-12) to either LTE-A Pro (CAT-18) or 5G, you will require additional antennas. 3. FlexModule Minis are fully interchangeable with other FlexModule Minis, e.g. Ethernet, and cellular.

the B380X/B580X Step 1: Power off the router. The router MUST be disconnected from power before starting the upgrade. Step 2: Disconnect all antennas. Step 3: Loosen the screws on the cover or the installed FlexModule Mini. Step 4: Remove the cover or module by pulling them out directly. https://www.peplink.com 2 Copyright @ 2021

which is for the Balance 20X. Step 6: Install the 380X/580X module cover and tighten the screws. Step 7: Install the new module. Make sure it is correctly aligned before pressing the module firmly into place. The FlexModule Mini should sit flush with the router chassis. https://www.peplink.com 3 Copyright @ 2021

Step 9: Reconnect the antennas. Step 10: Reconnect the power. https://www.peplink.com 4 Copyright @ 2021

the B20X Step 1: Power off the router. The router MUST be disconnected from power before starting the upgrade. Step 2: Disconnect all antennas. Step 3: Loosen the screws on the cover or the installed FlexModule Mini. https://www.peplink.com 5 Copyright @ 2021

Step 5: Install the new module. Make sure it is correctly aligned before pressing the module firmly into place. The FlexModule Mini should sit flush with the router chassis. Step 6: Tighten the screws until the FlexModule Mini sits flush and tight with the collar. https://www.peplink.com 6 Copyright @ 2021

Step 8: Reconnect the power. https://www.peplink.com 7 Copyright @ 2021

Federal Communications Commission (FCC) Compliance Notice: For FlexModule Mini Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and if it is not installed and used in accordance with the instruction manual, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. https://www.peplink.com 8 Copyright @ 2021

https://www.peplink.com 9 Copyright @ 2021

This equipment complies with CE radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. contact as: https://www.peplink.com/ https://www.peplink.com 11 Copyright @ 2021

https://www.peplink.com 12 Copyright @ 2021

This equipment complies with CE radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. contact as: https://www.peplink.com/ https://www.peplink.com 14 Copyright @ 2021