multicomp pro MP720774 Operation & User’s Manual

Observe the video circuit of a television, apply the video trigger and obtain the stable video output signal display. Video Field Trigger For the trigger in the video field, carry out operations according to the following steps: (1) Click to call up the menu panel. Click the Trig Menu softkey on panel to display the Trigger menu. (2) Select the first menu item in the bottom menu. Select Single in the right menu. (3) In the left menu, select Video as the mode. (4) Select Source in the bottom menu. Select CH1 in the right menu. (5) Select Modu i ...

via Wi-Fi (Optional) The oscilloscope supports communications with Android based smart device via Wi-Fi. You can use the free application software on the Android based smart devices to view the waveform synchronously, perform remote control, the waveform can be saved as image (BMP, PNG) or file (CSV, BIN), or shared via installed sharing apps. System Requirements of Mobile Devices  Android Versions: 4.0 and above How to Connect In Wi-Fi settings of the oscilloscope, there are two connection types. One is WIFI-AP (Access Point), the osci ...

allowed to pass. (4) Select 20M in the right menu. The bandwidth is limited to 20 MHz. The frequencies above 20MHz will be rejected. Use the upper knob and the lower knob If you want to set the vertical position and vertical scale of a channel, press CH1 or CH2 at first to select the desired channel, then turn the upper knob to set the vertical position, turn the lower knob to set the vertical scale. 1. The upper knob is used to adjust the vertical positions of the selected waveforms. The analytic ...

the router. Here we set the IP address to 192.168.1.71, Subnet mask is 255.255.255.0, Default gateway is 192.168.1.1. Figure 6-5 Set the network parameters of the computer (3) Set the network parameters of the Oscilloscope Software. Run the software on the computer; choose the "Ports-settings" of the "Communications" menu item. Set "Connect using" to LAN. About the IP, the first three bytes is same as the IP in the step (2), the last byte should be different. Here, we set it to 192.168.1.72. The range ...

Lost Trigger on Missing Ack. Error Trigger on Bit Stuffing Error. Mode Holdoff Auto Acquire waveform even no trigger occurred Normal Acquire waveform when trigger occurred Single When trigger occurs, acquire one waveform then stop Bus Decoding 1. UART Decoding To decode UART signal: (1) Connect the UART signal to the signal input channel of the oscilloscope. (2) Adjust to the proper time base and voltage division. (3) In trigger menu, select Bus trigger, and select bus type as UART, set parameters based on the characteristics of ...

Function in the bottom menu, select Display in the left menu. The description of Display Menu is shown as the follows: ●Adjust Click to call up the menu panel. Click the Utility softkey on panel, select Function in the bottom menu, select Adjust in the left menu. The description of Adjust Menu is shown as the follows: Function Menu Description Self Cal Carry out the self-calibration procedure. Default Call out the factory settings. Function Menu Setting Description Language Choose the di ...

the router. Here we set the IP address to 192.168.1.71, Subnet mask is 255.255.255.0, Default gateway is 192.168.1.1. Figure 6-5 Set the network parameters of the computer (3) Set the network parameters of the Oscilloscope Software. Run the software on the computer; choose the "Ports-settings" of the "Communications" menu item. Set "Connect using" to LAN. About the IP, the first three bytes is same as the IP in the step (2), the last byte should be different. Here, we set it to 192.168.1.72. The range ...