ring Wired Plus Installation Manual
Text of the manual
How to Use
How can we help?
Floodlight Cam Wired Plus Installation Guide
Before you begin
WARNING: Electrical shock hazard. Disconnect power to the installation area at your circuit breaker
or fuse box before beginning installation. Always use caution when handling electrical wiring.
Installation by a qualified electrician may be required in y
3. Turn off the power at the fuse box
You’ll be working with electrical wires during the install process. If you don’t know where the fuse
box is or how to turn off power to the floodlight circuit, we recommend you hire a licensed
electrician.
4. Prep your Floodlight Cam Wired Plus for installation
First, rotate the light out of the way, li
5. Remove your existing floodlight
1. With power off at the fuse box, remove the existing floodlight from the wall and disconnect the
wires. If there is a bracket attached to the wall, remove that as well.
2. Remove the plastic mounting plate from the light fixture.
Push gently on the threaded posts visible on the front of the fixture and pull the bra
Run the wires through the hole in the mounting plate.
Install the mounting plate with the two posts level with the ground, or level with the wall if mounting
on an eave or overhang. Ensure the “UP” arrow is pointing upwards for wall mounting, and away
from the area to be monitored for eave and overhang mounting.
Secure the plate with the two mounting scr
With power still turned off at the fuse box, slide the earth wire into the centre bay on the bottom of
the terminal block and tighten with the flathead end of the included screwdriver. Then slide the line
wire into the bay on the bottom of the terminal block marked “L” and tighten with the flathead end
of the screwdriver.
Repeat with the neutral wire, sl
