U-Line H-4455 Manual 

1213 IH-4455 π H-4455 MOBILE BLUEPRINT RACK 1-800-295-5510 uline.com 1. Position Frame Extension with holes toward the floor. Insert Frame Extension into the short end of the Side Frame tubes. (See Figure 1) 2. Slide posts of Upper Rack into the long end of the Side Frame tubes. (See Figure 1) 3. Install Casters to underside of frame by carefully screwing them in. Position both Locking Casters at the rear of the frame, closest to the Upper Rack. (See Figure 1) 4. Insert End Caps into the Upper Rack. (See Figure 1) 5. Insert Set Screws into Side Frames at four locations. Adjust to desired height and depth by using set screws and Allen wrench to lock in position. (See Figure 1) 6. Attach Lower Spreader Bar to Side Frames using two 1/4-20 x 3" Bolt and Washers. Fully tighten screws to secure bar in position. (See Figure 1) Set Screw ASSEMBLY INSTRUCTIONS PARTS Allen Wrench (Included) 11mm Wrench TOOLS NEEDED Upper Rack x 1 Lower Spreader Bar x 1 Side Frame x 2 Frame Extension x 1 Pivot Hanger x 12 Swivel Caster x 2 Locking Swivel Caster x 2 Washer x 2 Set Screw x 4 1/4 - 20 x 3" Bolt x 2 End Cap x 2 Figure 1

1213 IH-4455 ATTACHING THE PIVOT HANGERS 7. Attach pivot hangers to frame by inserting spring- loaded top post into top hole of Upper Rack, then inserting bottom post into bottom hole. (See Figures 2-4) Spring-Loaded Top Post ASSEMBLY INSTRUCTIONS CONTINUED Pivot Hanger Figure 2 Figure 3 Figure 4 π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA 1-800-295-5510 uline.com