RIOTEC LS6322A Programming Quick Manual

LS6322A./ FS5022A Installation Make sure that the scanner has the correct cable to plug in the PC as below described: *Note : Please install PL-2303 driver for USB serial Auto-sensing setup The auto-sensing features works when putting scanner on stand. When scanner removes from stand, scanner will become trigger mode. Reset Configuration to Defaults (For RS232, USB serial) If you are unsure of the scanner configuration or have scanned the incorrect codes, please scan the “Set Factory default” barcode. This will reset the scanner to its factory defaults. Default READING MODE Scan (Level) Scan (Pulse) * Scan (Level) - A trigger pull activates the laser and decode processing. The laser remains on and decode processing continues until a trigger release, a valid decode, or the Laser On Time-out is reached. * Scan (Pulse) - A trigger pull activates the laser and decode processing. The laser remains on and decode processing continues until a valid decode or the Laser On Time-out is reached. Redundancy Level This scanner offers two levels of decode redundancy. Select higher redundancy levels for decreasing levels of bar code quality. As redundancy levels increase, the decoder’s aggressiveness decreases. Select the redundancy level appropriate for the bar code quality. Redundancy Level 1 barcode must be successfully read twice before being decoded Redundancy Level 2 barcode must be successfully read three times before being decoded: 1D Symbologies On/OFF -1 ENABLE Code 128 DISABLE ENABLE ISBT 128 DISABLE ENABLE Code 39 DISABLE ENABLE Code 39 FULL ASCII DISABLE ENABLE Trioptic Code 39 DISABLE ENABLE UPC-A DISABLE ENABLE UPC-E DISABLE ENABLE EAN-8 DISABLE ENABLE EAN-13 DISABLE ENABLE CODABAR DISABLE

ENABLE Interleaved 25 DISABLE ENABLE Discrete 25 DISABLE ENABLE MSI DISABLE ENABLE Chinese 25 DISABLE ENABLE Matrix 25 DISABLE ENABLE GS1 DataBar DISABLE ENABLE GS1 DataBar Limited DISABLE ENABLE GS1 DataBar Expanded DISABLE 1D Symbologies On/OFF -3 ENABLE Composite CC-C DISABLE ENABLE Composite CC-A/B DISABLE ENABLE Composite TLC 39 DISABLE ENABLE Code 32 DISABLE ENABLE CODE 93 DISABLE ENABLE CODE 11 DISABLE ENABLE Interleaved 25 DISABLE ENABLE Discrete 25 DISABLE  Information in this document is subject to change without notice.  For more information, please visit: www.riotec.com.tw R_140708_01