PeakTech 1335 Manual 

2. Safety Terms and Symbols .......................................................................................... 4 3. Quick Start .................................................................................................................... 6 ...

Example 2: Gain of a Amplifier in a Metering Circuit ............................................................. 50 Example 3: Capturing a Single Signal .................................................................................. ...

for exact measurements). * Do not input values over the maximum range of each measurement to avoid damages of the instrument. * Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or solvents. * The meter is suitable for indoor ...

Hazardous Voltage Refer to Manual Protective Earth Terminal Chassis Ground Test Ground To Avoid body damage and prevent product and connected equipment damage, carefully read the following safety information before using the test tool. This product can only be used in th ...

Introduction to the Structure of the Oscilloscope This chapter makes a simple description of the operation and function of the front panel of the oscilloscope, enabling you to be familiar with the use of the oscilloscope in the shortest time. Front Panel The front panel has knobs and function buttons. The 5 buttons in the column on the right ...

1. Handle 2. Air vents 3. AC power input jack 4. Foot stool: Adjust the tilt angle of the oscilloscope. 5. USB Device port: It is used to transfer data when external USB equipment connects to the oscilloscope regarded as "slave device". For example: to use this port when connect PC to the oscilloscope by USB. ...

1. Function button area: Total 6 buttons. 2. Horizontal control area with 1 button and 2 knobs. "HOR" button refer to horizontal system setting menu, "Horizontal Position" knob control trigger position, " Horizontal Scale" control time base. 3. Trigger control area with 2 buttons and 1 knob. The Tri ...

Figure 1-4 Illustrative Drawing of Display Interfaces 1. Waveform Display Area. 2. Run/Stop 3. The state of trigger, including: Auto: Automatic mode and acquire waveform without triggering. Trig: Trigger detected and acquire waveform. Ready: Pre-triggered data captured and ready for a trigger. Scan: Capture and display the wavef ...

Rising edge triggering Falling edge triggering Video line synchronous triggering Video field synchronous triggering The reading shows the trigger level value of the corresponding channel. 14. It indicates the measured type and value of the corresponding channel. "T" means period, "F" means frequency, "V" means the average value, ...