Pentair HYDROBOOST Installation And User Manual

Typical Installation Connect the suction side of the booster pump after the filter to ensure a filtered water supply to the booster pump. The booster pump must be connected to the return line on the discharge side of the filter. INSTALLATION Location 1. Always connect the booster pump to a return line on the discharge side of filter. 2. Install the pump as close to the pool or spa as possible. To reduce friction loss and improve efficiency, use short, direct suction and discharge piping. 3. Install pump on a firm and level surface ...

Typical Installation Connect the suction side of the booster pump after the filter to ensure a filtered water supply to the booster pump. The booster pump must be connected to the return line on the discharge side of the filter. INSTALLATION Location 1. Always connect the booster pump to a return line on the discharge side of filter. 2. Install the pump as close to the pool or spa as possible. To reduce friction loss and improve efficiency, use short, direct suction and discharge piping. 3. Install pump on a firm and level surface ...

IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, include the following: Do not permit children to use this product. RISK OF ELECTRICAL SHOCK. Connect only to a branch circuit protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the circuit is protected by a GFCI. This unit must be connected only to a supply circuit that is protected by a ground-fault circuit-interrupter (GFCI). Such a GFCI s ...

Installing the Pump Hoses 1. Wrap the threads of the white 1” to 3/4” reducer bushing with thread seal tape or pipe joint compound. 2. Screw the white reducer bushing into the pump outlet. Hand tighten + one (1) turn with a 12” adjustable wrench. Torque = 60 in-lb (6.8 N-m). 3. Unscrew the adapter cap from the adapter. Wrap the threads with thread seal tape or pipe joint compound. 4. Screw the black adapter into the white reducer bushing. Hand tighten the adapter + one (1) and a quarter turns with a 12” adjustable wrench. ...

TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Pump motor does not run. Power is off. Circuit is tripped. Fan guard pushed against fan. Pump is in OFF mode in a timer controlled circuit. Motor terminal wiring is incorrect. Impeller is blocked by debris. Check power and reset. Check circuit breaker and reset. Move fan guard back into place with hammer and screwdriver. Check timer mode. Have terminal connections checked by an electrician. Clear debris from impeller. Reduced pump flow and/ or cleaner runs too slow. Inlet and ...

The Virginia Graeme Baker (VGB) Pool and Spa Safety Act creates new requirements for owners and operators of commercial swimming pools and spas. Commercial pools or spas constructed on or after December 19, 2008, shall utilize: (A) A multiple main drain system without isolation capability with suction outlet covers that meet ASME/ANSI A112.19.8a Suction Fittings for Use in Swimming Pools, Wading Pools, Spas, and Hot Tubs and either: (i) A safety vacuum release system (SVRS) meeting ASME/ ANSI A112.19.17 Manufactured Safety Vacuum Rele ...

Wiring the Pump for 115 VAC The booster pump is preset to operate on 230 VAC. The pump can also operate on 115 VAC by sliding the switch above the terminals to 115V. Wires must be run through a water tight connector to prevent water from entering the wiring compartment. Note: Never wire a 115 volt motor to a 230 volt line. 1. Ensure all electrical breakers and switches are off before wiring the motor and bonding wire is connected to the bonding lug. 2. Connect ground wire to green ground screw. 3. Ensure the voltage from power so ...