Electrolux 318 205 111 Use And Care Manual

Rack positions Installing Oven Rack Supports ALWAYS INSTALL OVEN RACK SUPPORT BEFORE TURNING ON THE OVEN (WHEN THE OVEN IS COOL). To install oven rack support, insert the supports by pushing them downward into the two brackets on each side of the oven interior, as shown below. To remove the oven rack support for a self-clean cycle, pull up the support to disengage them from the brackets. If the rack supports are not removed, the self- clean cycle won’t start. Oven Vents Location The oven is vented above each door. When the ove ...

BREAD PROOFING Proofing bread prepares the dough for baking by activating the yeast. This feature is ideal for proofing, or rising bread dough. The oven can be programmed for Bread Proofing at any temperature between 85°F to 100°F with a default temperature of 100°F. Bread Proofing Tips: • No need to preheat for this feature. • Proof bread until dough has doubled in bulk. • For best results, place a shallow pan with 1 to 3 cups of boiling hot water on the lowest rack position to keep the air moist inside the oven cavity. • Allow at least 1” between edge of pan and ...

When the unit is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "12:00". The clock cannot be set when the oven is on. If an invalid time of day is entered, the control will triple beep to prompt you to re-enter a valid time of day. To set the clock (example for 1:30): 1. Press 1 3 0 pads to set the time of day to 1:30. The pads + hi or - lo can also be pressed to raise or lower the actual time displayed. 2. Press START to accept the changes or CANCEL to start with a time of 12:00. SETTING CLOCK AT POW ...

OVEN CONTROL BEEPS AND DISPLAYS AN “F” ERROR CODE • Electronic control has detected a fault condition. Push CANCEL pad to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record the fault number, push the CANCEL pad and contact an authorized servicer. INSTALLATION • Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level. • Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and le ...