Whirlpool W10222384A Installation Instructions Manual

supply is required. A time-delay fuse or circuit breaker is recommended. It is also recommended that a separate circuit serving only this appliance be provided. To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. IMPORTANT: T ...

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed: WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; ...

An individual shutoff valve must be installed within six (6) feet (1.8 m) of the washer/dryer in accordance with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. The location should be easy to reach for opening and closing. Burner input requirements: Elevations up to 10,000 ft (3,048 m): The design of this washer/dryer is certified by CSA International for use at altitudes up to 10,000 ft (3,048 m) above sea level at the Btu rating indicated on the model/serial number plate. Burner input adjustments are not required when the dryer is operated up to this elevatio ...

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed: WARNING: For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, or to prevent property damage, personal injury, or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; ...

1. Attach the hot water hose to the bottom inlet valve. Attaching the hot water hose first makes it easier to tighten connection with pliers. 2. Screw on coupling by hand until it is seated on the washer. 3. Using pliers, tighten the couplings with an additional two- thirds turn. NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result. 4. Attach the cold water hose to the top inlet valve. 5. Screw on coupling by hand until it is seated on the washer. 6. Using pliers, tighten the couplings with an additional two- thi ...

This washer/dryer can be converted to exhaust out the right or left side. To convert the washer/dryer, use Side Exhaust Kit Part Number 279823. If your washer/dryer was previously exhausted from the right or left side, it can be converted to rear exhaust by using standard offset connections. To cover the hole in the side, one of the following plugs can be added: 692790 (white) 3977784 (biscuit) Follow the instructions in the kit to install. Kits are available from the dealer from whom you purchased your washer/dryer. Alternate installations for close clearance ...