Elmira Stove Works 1850 Installation And Operating Instructions For

• Touch OFF • Hot lights are provided in the glass of all smooth top ranges. Light glows when a burner becomes hot and shuts off when the burner has cooled. • H or 9 – To start foods cooking and to bring foods to a boil. • 8-7 – To hold a rapid boil. • 6-5 – To fry foods. • 4 – To cook large amounts of vegetables • 3-2 – To keep food cooking after starting it on a lower setting. • L – To keep foods warm until ready to serve. Controls The radiant heating elements are controlled by a commonly used Infinite Heat Switch that work ...

enlarge or distort port. Do not leave anything stuck in the ports when replacing black porcelain burner base. 5. After cleaning the orifice opening and ports, replace the burner cap. Make sure cap is set straight on burner and that the tabs on cap fit into the grooves of burner base. 6. Check the burner for proper lighting after cleaning. Note: If a gas burner burns with an uneven orange flame, reposition the burner cap so it sits flat on the burner housing. If burner lights slowly, have your gas service person check the gas pressure ...

to the range body with the green ground screw. • Check power with multimeter. You must have 110 volts between white and black. You must have 110 volts between white and red. You must have 220 volts between red and black. If range receptacle is wired wrong, clock transformer will be severely damaged and will not be covered by manufacturer’s warranty. Replace back panel of range. Plug the power cord in and turn power on. Leveling Your Range Safety Instructions – Gas Important Instructions Do not use range as a heater. Never us ...

more stubborn spots, use a slightly dampened non- impregnated plastic or nylon pad specially made for non-stick utensils. • Use liquid cleansers to remove any discoloration, especially in hard water areas. A non-impregnated plastic or nylon pad specially made for non-stick utensils may also be used with these cleaners. Do not apply excessive pressure while rubbing. This could cause scratches over time. • Apply cleaner-conditioner and polish with paper towel or a soft dry cloth. • Any smearing or hazing on the surface may be remo ...

inspector’s use. Warning! Prior to installing this appliance, read the Safety Instructions as they relate to Installation on pages 3 through 7 of this manual. Failure to follow these instructions could result in serious electric hazard, risk of fire, and/or personal injury. Models 1850, 1855, 1865, 1870 & 1875 are equipped with a 240 volt, standard range power cord & plug. See page 4 for amp ratings of each model. Models 1860 & 1867 come with a 120 volt, 5 amp power cord & plug. Use this appliance for its inten ...