ESI Juli@ Operation & User’s Manual

case or something grounded. We recommend you use an anti-static device such as an anti-static wristband. When holding the Juli@ card, touch only the guide or the edge of card. Do not grab the card by the board or connector. PCI Card Installation Find an empty PCI slot on the motherboard Typical PC Motherboard Slot Configuration Removing the PCI Slot faceplate If the PCI slot is covered by a faceplate, you can remove it by removing the screw holding it in place or by prying it off wit ...

Before installing the drivers of Juli@, we recommend to check on the download section of www.esi-audio.com for updated drivers. Windows XP Turn on your computer. Windows will automatically detect a new device installation and the Found New Hardware Wizard window will appear as seen on the following picture on the left. Select No, not this time and click Next. On the following dialog select Install from a list or a specific location (Advanced) and click Next. The dialog below will appear. Make sure to select Search for the best driver in these locati ...

* Unbalanced Part 1) Connector Type : Gold-plated RCA female (line in 1 and 2) 2) Peak level : 0dBFS @ +6dBV (-10dBV nominal) 3) Impedance : 10k ohms minimum * Balanced Part 1) Connector Type : 1/4" female TRS-type, balanced or unbalanced(line in 1 and 2) 2) Peak level : 0dBFS @ +20dBu (+4dBu nominal) 3) Impedance : 10k ohms minimum 2. Analog Ouputs * Unbalanced Part 1) Connector Type : Gold-plated RCA female (line out 1 and 2) 2) Peak level : +6dBV @ 0dBFS (-10dBV nominal) 3) Impedance : 100 ohms minimu ...

This chapter contains basic configuration examples for some software applications. Please also refer to the manual of the audio software you use for detailed information. Windows Multimedia Setup The Windows multimedia setup is required if you want to use your Juli@ as the main sound device for Windows multimedia applications. Go to My computer-> Control panel -> Sounds and Audio Device Properties -> Audio. Select the Juli@ entry as your playback device to make sure that all standard signals are played via the Juli@ hardware. Please note that some advanc ...

and off) of the respected drivers. Patch the virtual cables from one point to another as you drag your mouse point. INPUT section: It's used to route signals from the card's hardware inputs. MME section represents general application's I/O: Ex.) WinAmp, WaveLab (non ASIO mode), Cakewalk, Audition, Vegas, etc. WDM section represents Multi-MME application’s I/O: Ex.) SONAR (when using WDM/KS), PowerDVD, WinDVD, etc. ASIO section represents ASIO application’s I/O: Ex.) Cubase, Reason ...

mouse, mouse wheel, or cursor keys. MASTER FADER Allows you to change the level of the final output signal. The level can be set using the mouse, mouse wheel, or cursor keys. MUTE Select this button to mute each signal source. Sample Rate and Clock Sample Rate Selects the sample rate for Juli@. The green lit will indicate current sample rate. Juli@ supports 44.1, 48, 88.2, 96, 176.4, 192 (kHz) as sample rates. Select ‘AUTO’ to match the sample rate of the played audio source ...

O O Caution: Don’t touch the chipsets on the card like shown on the following picture. Otherwise the card could be damaged. X X ...