EUROCOM M350C MILANO Operation & User’s Manual

8 Operation Problem Possible Cause - Solution The system freezes or the screen goes dark. The system’s power saving features have timed-out. Use the AC adapter, press the sleep (Fn + Esc) key combination, or press the power button if no LEDs are lit. A software conflict made the system “crash”. Consult your OS manual. As a last resort, since you will lose any unsaved data, try to reboot the system or if that doesn’t work, turn the computer off and on again. The system never goes into Hibernate mode. Make sure you have enabled Hibernate in the Power Opti ...

8 The battery pack will not charge and the charge indicator light is off. The battery is already fully charged and the indicator light is broken. A beeping sound is heard and the low-battery indicator is on. The battery power is nearly used up. Connect the AC adapter to your computer. A beep isn’t heard when the low-battery indicator turns on, or the gauge indicates power is less than 10%. The battery power is nearly used up and the volume control may be turned down. Adjust the volume control and connect the computer with the AC adapter. Actual battery operating t ...

Upgrading the Hard Disk Drive 6 - 5 6 Hard Disk Removal (Model A) 1. After removing the cover (see page 6 - 4), slide the hard disk assembly in the direction of the arrow by carefully, but firmly, gripping the plastic tab. 2. Lift the hard disk assembly up out off the computer, and remove screws - in order to separate the cover from the hard disk. 3. Reverse the process to install a new hard disk (pay careful attention to the orientation of the disk in the case). 1 2 5 Figure 6 - 3 HDD Assembly Removal (Model A) 2 3 5 4 1 ...

3 Conserving Power (Individual Components) Turn off Monitor To conserve power, you can set the monitor to turn off after a specified time. Turn off Hard Disk The computer's hard disk motor will be turned off if the hard disk drive has not been accessed for a specified period of time. If the system reads or writes data, the hard disk motor will be turned back on.  Resuming Operation The system can re- sume from Monitor or Hard Disk Standby by pressing a key on the keyboard. Figure 3 - 13 Power Schemes ...