EverFocus EHD360 Operation Instructions Manual
Text of the manual
High Resolution Vandal Proof
Weather Resistant 3-Axis IR Dome Camera
Operation Instructions
Model No. EHD360
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve i
Use the camera at temperatures within -10°C to +50°C (14°F to 122°F) and in an IP66
compliant environment; this device is not rated as submersible. The input power source is
12VDC. Be sure to connect the proper + / - polarity and voltage, as incorrect polarity or
too high a voltage will likely cause the camera to fail, and such damage is not covered
by
Camera Unit x 1
Mounting kit includes:
-Screws x 4
-Security wrench for housing screws x 1
-Expanding Screws x 4
-Washers x 4
Operation Instructions (this document) x 1
Weatherproof bushing x 1
Power cable x 1
Video cable x 1
Power adapter pigtail (for NTSC model only) x 1
Mounting template x 1
SPECIFICATIONS
Pickup Device
1/3" SONY Super H
Drill the Holes
1. Locate the desired mounting location; position housing with camera pointed generally in the
desired direction and mark location.
2. Use template to fix hole locations. Drill 4 holes for mounting screws and insert plastic anchors
into holes after drilling.
Mounting Steps
1. Use the security wrench prov
3. Tighten the 4 mounting screws to secure the camera body to the mounting surface.
3. If you need to wire cable through side conduit hole, use a coin to remove the conduit plug;
save the plug as it will be used to close the rear conduit hole.
4. Disconnect the power and video wire from the camera board end of the wire. Gently pull the
wire out from under
