Fellowes POWERSHRED 385Ci Instructions Manual

POWERSHRED TM 385Ci/385i Please read these instructions before use. Do not discard: keep for future reference.

instruction manual. Read the entire instruction manual before operating shredders. • Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use. • Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse ( ) to back out object. • Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder. • Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water. • This shredder has a Disconnect Power Switch (G) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately. • Avoid touching exposed cutting blades under shredder head. • Use only designated entry for CDs/cards. Keep fingers away from CD entry. • Do not put foreign objects in paper entry. • Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. • FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries. • For indoor use only. • Unplug shredder before cleaning or servicing. KEY A. SafeSense® Technology B. Paper entry C. CD, credit card and junk mail entry D. Door E. Casters F. See safety instructions G. Disconnect power switch 1. OFF 2. ON H. Oil reservoir 385Ci only I. Oil drain plug (inside) 385Ci only J. Basket K. Accessory tray L. Control panel 1. Sheet capacity indicator 2. Low oil indicator (red) 385Ci only 3. Bin full (red) 4. SafeSense® (yellow) 5. Remove paper (red) 6. Door open (red) 7. Straight feed (red) 8. Auto button 9. Reverse 10. ON/OFF (blue) 11. Forward 11. 10. 9. 1. 8. 7. 6. 5. 4. 3. 2. G. F. A. C. B. D. E. L. IMPORTANT SAFETY INSTRUCTIONS — Read Before Using! CAPABILITIES Will shred: Paper, 132 column continuous form, credit cards, CD/DVDs, staples, paper clips and junk mail Will not shred: Adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above Paper shred size: Cross-Cut (385Ci)..........................................................................................4mm x 30mm Strip-Cut (385i)....................................................................................................... 5.8mm Maximum: Sheets per pass, 80g paper (Cross-cut).....................................................................22-24* Sheets per pass, 80g paper (Strip-cut)......................................................................24-26* CDs/Cards per pass........................................................................................................ 1* Paper entry width (385Ci, 385i)............................................................................. 407mm *A4, paper at 220-240V/50/60 Hz, 6Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Maximum recommended daily usage rates: 8,000 sheets per day, 300 credit cards; 30 CDs. Fellowes SafeSense® shredders are designed to be operated in office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity. 2

AUTO C-485C 1 Press the auto and forward buttons at the same time for 3 seconds to manually oil shredder Before using, fill oil reservoir with 12 oz. (355 ml.) of Fellowes shredder oil To maintain shredder performance, refill oil reservoir with up to 12 oz. (355 ml.) of shredder oil (Fellowes #35250) Low oil indicator will signal when your reservoir needs refilling Once refilled, automatic oiling will resume SET-UP AND TESTING REFILLING OIL 1 AUTO C-485C 2 Lubricates the cutters automatically to enhance performance and extend shredder life (Auto oil system is only included on cross-cut models - 385Ci.) AUTO C-485C 2 AUTO AUTO Eliminates paper jams and powers through tough jobs. JAM PROOF SYSTEM OPERATION* *100% Jam Proof when used in accordance with user manual Straight Feed Advanced Jam Prevention- Electronically measures paper thickness to prevent paper jams: Remove several sheets until indicator is below red. Continue 100% Jam Proof Shredding If a misfeed occurs: If illuminates after paper has been reversed, press reverse and remove paper. Otherwise, regular shredding will resume. 1 2 Up to RED: Too many sheets have been inserted. Up to GREEN: More sheets can be added. Up to YELLOW: Productivity is optimized. All indicators light up and shredder pauses for 3-6 seconds Wait for flashing to stop after automatic correction is complete. Regular shredding will resume. If Straight Feed indicator illuminates, remove paper and feed straight into shredder. BASIC SHREDDING OPERATION Press ( ) ON/OFF to activate (blue) Feed paper into paper entry and release Plug in and put disconnect power switch in ON (I) position Feed CD, credit card or junk mail into designated entry and release or Set to Off ( ) or shredder will automatically go into sleep mode after 2 minutes of inactivity 5 1 AUTO C-485Ci AUTO C-485Ci 3 4 2 Advanced product features AUTO C-485Ci 3 Auto OilTM Lubricates the cutters automatically to enhance performance and extend shredder life. SafeSense® Technology Stops shredding immediately when hands touch the paper opening. Jam Proof System Eliminates paper jams and powers through tough jobs. Energy Savings System Optimal energy efficiency 100% of the time – in use and out of use. 3 3

PRODUCT MAINTENANCE Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry.) TO CLEAN THE SENSORS Turn off and unplug shredder Lift CD flap Locate Auto-start infrared sensor Dip cotton swab in rubbing alcohol Using cotton swab, wipe away any contamination from the paper sensors 4 C-485C 3 C-485C 5 1 AUTO C-485C 2 REFILLING THE OIL Low oil indicator will signal when your reservoir needs refilling To maintain shredder performance, refill oil reservoir with up to 12 oz. (355 ml.) of shredder oil (Fellowes 35250) Once refilled, automatic oiling will resume • All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. We recommend that you refill the Auto OilTM reservoir as instructed for optimum performance. • If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain, remove plug and let oil drain out. Replace plug. AUTO OILTM Automatically oils the cutters to enhance performance and extend shredder life. (Auto oil system is only included on cross-cut models - 385Ci) AUTO C-485C 2 1 ENGLISH Models 385Ci/385i AUTO C-485Ci 3 SafeSense® is active and working properly SAFESENSE® TECHNOLOGY Stops shredding immediately when hands touch the paper opening. Touch test area and look for the SafeSense® indicator to illuminate Turn the shredder ON ( ) to activate SafeSense® SET-UP AND TESTING AUTO C-485Ci 2 1 AUTO C-485Ci 3 Advanced product features ENERGY SAVINGS SYSTEM • Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode and sleep mode. • Sleep Mode shuts down shredder after 2 minutes of inactivity. Optimal energy efficiency 100% of the time – in use and out of use. For more information about all of Fellowes Advanced Product Features go to www.fellowes.com/au AUTO C-485Ci 3 AUTO C-485Ci WHEN IN SLEEP MODE 1 In sleep mode To get out of sleep mode touch control panel insert paper or 2 If hand is held on SafeSense® area more than 3 seconds shredder will shut off AUTO C-485Ci 4 4

LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 20 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer. Should you choose to disable the system, press and hold the auto and reverse ( ) buttons at the same time DISABLING THE FEATURE Once disabled, the blue Auto light is no longer illuminated (To re-engage, repeat step 1) Shredding can continue with the system disabled; however, a paper jam may occur with too many sheets and Remove Paper icon ( ) will illuminate If jam occurs, press and hold forward ( ) button until the document is completely through the shredder If not cleared, press reverse ( ) briefly (repeat steps 4 and 5 until shredded) If steps 4 and 5 do not clear jam, reverse paper all the way out, remove several sheets and refeed AUTO 2 AUTO C-485Ci 3 4 45 AUTO C-485Ci 6 TROUBLESHOOTING Eliminates paper jams and powers through tough jobs. JAM PROOF SYSTEM* *100% Jam Proof when used in accordance with user manual AUTO C-485Ci 1 AUTO AUTO Straight Feed Indicator: When illuminated, remove paper and feed straight into paper entry. Low Oil Indictor: When illuminated, the shredder is out of oil and needs to be refilled. See the Product Maintenance section for refill instructions. For optimum performance, use Fellowes oil (35250). *Auto Oil™ is only featured on cross cut model – 385Ci. Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36055. Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the door to resume shredding. Remove Paper Indicator: When illuminated, press reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry. SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding. 5 Australia Residents Only: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.

This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive. For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE W.E.E.E. Australia +61-1-800-33-11-77 Europe 00800-1810-1810 United Kingdom +44-(0)-1302-836800 United States +1-800-955-0959 Questions or Concerns? www.fellowes.com Troubleshooting Registration Manuals Customer Service & Support Troubleshooting Replacement parts General questions Declaration of Conformity Fellowes Manufacturing Company Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Models 385Ci and 385i conform with the requirements of the Restriction of Hazardous Substances Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directive (2002/96/EC), and below harmonized European EN Standards: Safety: EN 60950-1 EMC Standard: EN55014-1 EN55014-2 EN61000-3-2 EN61000-3-3 Year Affixed: 13 Itasca, Illinois, USA June 1, 2013 James Fellowes