Fishman LOUDBOX ARTIST Operation & User’s Manual

6. Channel 2 Effects Loop (serial) Patch an external effect through these jacks. Use a standard ¼” shielded instrument cable to connect the Channel 2 Send to the input of the effect. Connect the Channel 2 Return jack to the output of the effect. The Channel 2 loop is located post-EQ and is compatible with battery-operated stompbox- style effects processors. 7. Channel 2 D.I. Out (Pre-EQ) Use this output when you want a flat D.I. signal to send to a mixing console. This pre-EQ output is always ground isolated to prevent ground loop hum. 8. Channel 1 Effects Loop (serial ...

To ensure your personal safety and the safety of others, operate this apparatus only after reading these instructions and heeding the warnings listed below. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block the ventilation openings. Install in accordance with the manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that p ...

7. Anti-Feedback If you encounter low-frequency feedback, sweep this control to isolate and eliminate it. To learn more about acoustic feedback, see page 9. 8. Phase Use the Phase switch in conjunction with the Anti-Feedback filter to eliminate acoustic feedback. To read more about acoustic feedback, see page 9. 9. Effect A Level Controls the amount of Effect A in the input channel. 10. Effect B On When this button is lit, the input channel’s audio is processed by Effect B. 11. Effect A Use this control to select one of four effects for Effect A. 12. Effect A “Time” ...