Frigidaire FGGS3065KWE Installation Instructions Manual

iMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR"SUSE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. 1 If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. I FOR YOUR SAFETY: -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT TO DO iF YOU SMELL GAS: * Do not try to light any appliance. * Do not touch any electrical switch; do not use any phone in your building. * immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. if you cannot reach your gas supplier, call the fire department. -- installation and service must be performed by a qualified installer, service agency or the gas supplier. Refer to your serial plate for applicable agency certitication Appliances installed in the state of Massachusetts: This Appliance can only be installed in the state of Massachusetts by a Massachusetts licensed plumber or gasfitter. This appliance must be installed with a three (3) foot / 36 in. long flexible gas connector. A"T" handle type manual gas valve must be installed in the gas supply line to this appliance. Do not install the unit in the cabinet before 30" Min. reading next page. (76.2 cm Min.), _h_e_e_u(_atcehS_! " "_ M';n. tsee'N-ote-.3)' _ 13" 5" Min _ \ _ (33cm) Shave 1 Y2 Max. From Wa Both _Ides\_ _ (45.7 cm) Mm. __ "m_ (12.7 cm Min.) 18 M,, . Raised (3.8 cm Max.) Edge _ [ ....... to Clear ,/ q _ ___ -li/4" rnin,_ Space ___- / I_Ic------3__/2",'min, // ' >-- J'/ (81 cm)Wide / G _Xd_L I _ Alqlq V Cooktop. _ | _ Approx. 1 7/8" J F ]] j Locate Cabinet Doors 1" (2.5 J __::::_: _ _'_ ...... .... i cm) Min. from Cutout Opening. _ ___ W j .............. /_x_ Grounded Jonction Box or Wall Outlet Should Be Located 8" to 17" (20.3 cm to 43.2 cm) From Right Cabinet and 2" to 4" (5.1 cm to 10.2 cm) From Floor. A HEIGHT (Under Cooktop) 35 7/8" (91,1 cm) 36 5/8" (93 cm) NOTE: Wiring diagram for these appliances are enclosed in this booklet. Printed in United States B. WIDTH C: COOKTOP D; TOTAL DEPTH TO E. CUTOUT WIDTH*** F; CUTOUT [ GI HEIGHT [ W!DTH , FRONTO F RANGE (C0unte_op DEPTH OF COUNTER-FO P and cabinet) 30" (76,2 cm) 31 1/2" 285/16" (71,9 cm) 30_+1/16" 21 3/4" (55,2 cm) Min. 357/8" (91,1 cm) Min. (80 cm) (76,2_+0,15 cm) 22 1/8" (56,2 cm) Max 24" (61 cm) Min. with 36 5/8" (93 cm) Max. backguard P/N 318201691 (1007) Rev. A English- pages 1-11; Espahol- p_ginas 12-22; Fran_ais - pages 23-33; Notes 34-35; Wiring diagrams - Pages 36

flexible gas conduit between the range and the wall. 2. Do not seal the range to the side cabinets. 3.24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when the bottom of wood or metal cabinet is protected by not less than ¼" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015 "(0.4 ram) stainless steel, 0.024"(0.6 ram) aluminum, or 0.020" (0.5 ram) copper. 30" (76.2 cm) minimum clearance when the cabinet is unprotected. 4. For cutouts below 22 7/8"(58.1 cm), appliance will slightly show out of the cabinet. 5.Allow at least 19 ¼" (48.9 cm) clearance for door depth when it is open. Door Open / I Panel *** IMPORTANT: To avoid cooktop breakage for cutout width (E dimension) of more than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while pushing into it. Raise leveling legs at a higher position than the cabinet height (see page 3), insert the appliance in the counter and then level. Make sure the unit is supported by the leveling legs and NOT by the cooktop itself. IM PORTANT: Cabinet and countertop width should match the cutout width. E E 22 7/8"(58.1 cm) min. 23 1/4"(59.05 cm) max. - (see Note 4) -_ __| _ 1 118" ' (2.86 cm) FRONT OF CABINET _ FRef.-- r A HEIGHT ' B:WIDTH " C: CooKToP D. TOTAL DEPTH TO E. CUTOUTWIDTH***. F: CUTOUT I G: HEIGHT (Under Cooktop) , WIDTH FRONTOF RANGE (Countertop ] DEPTH OF COUNTERTOP I ! ! I and cabinet) i i 35 7/8" (91,1 cm) 30"(76,2cm) 31 1/2" 28 5/16" (71,9cm) 30_+1/16" 21 3/4" (55,2cm) Min. 35 7/8" (91,1 cm) Min. (80 cm) (76,2_+0,15 cm) 22 1/8" (56,2 cm) Max 36 5/8" (93 cm) 24" (61 cm) Min. with 36 5/8" (93 cm) Max. backguard

or manipulate the unit by the cooktop. The counter-top around the cut-out should be flat and leveled (see hatched area on illustration 1). Before installing the unit, measure the heights of the two (2) cabi- net sides (H1-4), front and back (see illustration 1) from the floor to the top of the counter• Level the range using the four (4) leveling legs, so that the height from the floor to the underside of the metal flange is greater than the tallest cabinet measurement by at least 1/16" (see illustration 2). Shave Raised Edge to Clear Space for a 1 1/2"Max. I (3.8 crn Max.) I 311/2" (81 cm) Wide Cooktop. Slide the unit into the cabinet• Make sure the center of the unit is aligned with the center of the cabinet cut-out• Remove the protective channels on each side of the cooktop (if provided)• The metal flange under each side of the cooktop MUST be placed / over the cabinet countertop for proper unit support• The cooktop should NOT rest directly on the countertop (see illustration 2) or else it could cause damage to the cooktop voiding the warranty• Level the unit if needed• After the installation, MAKE SUREthat the unit is supported by the two front leveling legs and the two adjustable leveling wheels and NOT by the cooktop. \ Illustration 1 1 successfully "install the range, the initial level height from floor to underside of cooktop frame should be at least 1/16" taller than cabinet sides as measured in step 2. Illustration 2 3

contained in these installation instructions before installing range. 2. Remove all packing material from the oven compartments before connecting the gas and electrical supply to the range. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Note: For operation at 2000 ft. elevations above see level, appliance rating shall be reduced by 4 percent for each additional 1000 ft. important Note to the Consumer Keep these instructions with your Owner's Guide for the local electrical inspector's use and future reference. IMPORTANT SAFETY INSTRUCTION _l_i_lCold temperatures can damage the electronic control. When using the appliance for the first time, or when the appliance has not been used for an extended period of time, be certain the unit has been in temperatures above 32% (0°C) for at least 3 hours before turning on the power to the appliance. Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1 / NFPA54 or CAN/ACG-B149.1 and CAN/ACG-B149.2. This range has been design certified by CSA international. As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find them in the Use and Care Guide, read it carefully. • Be sure your range is installed and grounded properly by a qualified installer or service technician. This range must be electrically grounded in accordance with local codes or, in their absence, with the National Electrical Code ANSI/NFPA No. 70-- latest edition in United States or with CSA Standard C22.1, Canadian Electrical Code, Part I in Canada. See Grounding Instructions. persons could result. Install anti- tip device packed with range. All ranges To reduce the risk of can tip. tipping of the range, the Injury to range must be secured by properly installed anti-tip bracket provided with the range. To check if the bracket is installed properly, grasp the top rear edge of the range and carefully tilt it forward to make sure the range is anchored. Before installing the range in an area covered with linoleum or any other synthetic floor covering, make sure the floor covering can withstand heat at least 90°F above room temperature without shrinking, warping or discoloring. Do not install the range over carpeting unless you place an insulating pad or sheet of 1/4" (10,16 cm) thick plywood between the range and carpeting. Make sure the wall coverings around the range can withstand the heat generated by the range. Do not obstruct the flow of combustion air at the oven vent nor around the base or beneath the lower front panel of the range. Avoid touching the vent openings or nearby surfaces as they may become hot while the oven is in operation. This range requires fresh air for proper burner combustion. Never leave children alone or unattended in the area where an appliance is in use. As children grow, teach them the proper, safe use of all appliances. Never leave the oven door open when the range is unattended. Stepping, leaning or sitting on the doors or drawers of this range can result in serious injuries and can also cause damage to the range, Do not store items of interest to children in the cabinets above the range. Children could be seriously burned climbing on the range to reach items. To eliminate the need to reach over the surface burners, cabinet storage space above the burners should be avoided. Adjust surface burner flame size so it does not extend beyond the edge of the cooking utensil. Excessive flame is hazardous. Do not use the oven as a storage space. This creates a potentially hazardous situation. Never use your range for warming or heating the room. Prolonged use of the range without adequate ventilation can be dangerous. Do not store or use gasoline or other flammable vapors and liquids near this or any other appliance. Explosions or fires could result. In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit match to the burner head and slowly turn the Surface Control knob to LITE. Use caution when lighting surface burners manually. Reset all controls to the "off" position after using a programmable timing operation, FOR MODELS WITH SELF-CLEAN FEATURE: Remove broiler pan, food and other utensils before self-cleaning the oven. Wipe up excess spillage. Follow the predeaning instructions in the Use and Care Guide. Unlike the standard gas range, THIS COOKTOP IS NOT REMOVABLE, Do not attempt to remove the cooktop. 4

Youwillfindthemodeland serialnumberprintedonthe serialplate.Theserialplateis locatedasshown. Remember to recordthe serialnumberforfuture reference. Electrical connection IMPORTANT Please read carefully. For personal safety, this appliance must be properly grounded. The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from the appliance. | Cabinet Construction To eliminate the risk of burns or fire by reaching over heated surface units, do not have cabinet storage space above the range. If there is cabinet storage space above range, reduce risk by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinet. Countertop Preparation • The cooktop sides of the range fit over the cutout edge of your countertop. If you have a square finish (flat) countertop, no countertop preparation is required. Cooktop sides lay directly on edge of countertop. Formed front-edged countertops must have molded edge shaved flat 3/4" (1.9 cm) from each front corner of opening (Figure 2). Tile countertops may need trim cut back 3/4"(1.9 cm) from each front corner and/or rounded edge flattened (Figure 2). The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded. Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3-prong wall receptacle. Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. Disconnect electrical supply cord from wall receptacle before servicing cooktop. Preferred Method Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. (1.9cm) I (81crn) Formed or tile countertop trimmed %" (1.9 cm) back at front corners of countertop opening. Figure 2 If the existing cutout width is greater than 30 1/16" (76,4 cm), reduce the 3A" (1.9 cm) dimension. Countertop must be level, Place a level on the countertop, first side to side, then front to back. If the countertop is not level, the range will not be level. The oven must be level for satisfactory baking results. Cooktop sides of range fit over edges of countertop opening. Power supply cord with 3-prong grounding plug. Figure I