Sanyo SANUPS E11A202U Instruction Manual

Note: Changes to some menu items do not take effect until you restart the UPS. These items are indicated by (RESTART) in the "Menu Item" column. If a restart is required, be sure to power off the load devices before resetting. See §9.5 “UPS Shutdown (If Not to Be Used for More Than a Week)” for information about how to shut down the UPS, and §9.1 “UPS Startup (Normal Operation)” for information about how to start the UPS.Set “⑯ Reset remaining life” after change “⑬ Battery backup time”. ...

5. External Dimensions and Part Names 5.1 Front and Back Panels Depth: 565 mm (22.24 inch) Weight: 29 kg (63.93 lbs) No. Name Label Function ① Control panel and indicators － Control panel for control operations, UPS status display, and function settings ② Forced bypass switch Forced Bypass Switch to bypass UPS during maintenance ③ Battery connector － Battery connector ④ Card interface CARD I/F Connector for external signal transfer ⑤ PC interface PC I/F Connector for external PC-WS signal transfer ⑥ Exhaust vent － Ventilation ⑦ Option card slot OPTION CARD Option ...

5.3 External Interfaces UPS back panel No. Name Function ① PC I/F (PC interface) (RS-232C) Allows you to control the UPS from a computer (PC or workstation) by using the supplied power management software. Install the power management software (*2) on the computer, and connect the computer to the UPS with the supplied network cable. Interface mode (*1): Workstation mode (*1): Use the controls on the front panel to set the interface mode. For more information, see item ⑤ PC Interface mode in §10.1 “Setup Menu Item List”. (*2): For more information, refer to the User Guide in ...

13. Alarm Sounds The alarm buzzer emits sound patterns to alert you to failures and error conditions in the UPS. Check the sound pattern and refer to the following table to for the steps to take. Sound Pattern UPS Status What to Do This is a mechanical failure. Contact your supplier. During bypass operation The bypass breaker is tripped. Reset the bypass breaker. See §11.7 “Bypass Breaker Reset”. Continuous tone ＊ The battery is exhausted. The UPS will restart automatically when utility power is restored. Power is being supplied from the battery because of an input voltage or ...

9.4 UPS Shutdown (Daily) Note Do not touch MAIN MCCB when you perform a daily shutdown. Leave it set to the “ON” position. *Note The length of time to keep held down varies depending on the setting of item “⑨ switch response time” in §10.1 “Setup Menu Item List”. Operate as follows. When “1 second” is selected: Hold for 1 second. When “3 seconds” is selected: Hold for 3 seconds. When “Special operation” is selected: Hold for 3 seconds until the buzzer starts beeping, and then hold for 3 seconds more while the buzzer is beeping. 9.5 UPS Shutdown (If N ...

13. Alarm Sounds The alarm buzzer emits sound patterns to alert you to failures and error conditions in the UPS. Check the sound pattern and refer to the following table to for the steps to take. Sound Pattern UPS Status What to Do This is a mechanical failure. Contact your supplier. During bypass operation The bypass breaker is tripped. Reset the bypass breaker. See §11.7 “Bypass Breaker Reset”. Continuous tone ＊ The battery is exhausted. The UPS will restart automatically when utility power is restored. Power is being supplied from the battery because of an input voltage or ...