Fujitsu Solaris 10 Hardware Platform Manual

No Recommended actions Remarks There are some differences in behavior of MIB between SNMP agents of SMA and SEA. z sysObjectID (MIB to show system device type) SEA shows the value as “enterprises.42.2.1.1”, however, SMA shows the value as “netSnmpAgentOIDs.3”. z snmpEnableAuthenTraps (MIB to show permission of trap of authorization failure) SEA shows the value as “enabled(1)”, however, SMA shows the value as “disabled(2)”. z ifSpeed (MIB for supported bandwidth speed of the network interface) The results may be different between SEA and SMA. z ifTy ...

When backing up a disk unit, use the dd(1M) command. The following describes how to back up a disk unit to a tape device using the dd(1M) command. The backup records physical properties such as disk space and a number of cylinders, so it is only possible to restore to a disk having the same physical properties. The prtvtoc(1M) command displays the physical properties as " Dimensions." # prtvtoc XXXX Specify the slice 2 of character special disk (/dev/rdsk/...) to be backed up such as "/dev/rdsk/c0t0d0s2" with the format(1M) co ...

Purpose This manual provides notes necessary after installing the Solaris 10 on PRIMEPOWER. Intended Readers This manual is intended for system administrators who install Solaris™ Operating System (Solaris) and operate it. Readers are expected to have the basic knowledge of a system administrator. Organization This manual is organized as follows: z Chapter 1 Notes after the Installation This chapter describes post-installation notes. z Chapter 2 Backup and Restore of System Disk (PRIMEPOWER 1/200/250/400/450/600/65 ...

No Recommended actions Remarks For growfs(1M), the following patch is required to be installed. 120254-02 or later SunOS 5.10: ufs Patch 5 Install the above patches. Solaris 10 3/05 and 1/06 only When using any of the following PGX cards and monitors, the display monitor does not enter standby mode if you haven’t logged on from CDE (Common Desktop Environment). z PGX frame buffer (X3660A) z PGX64 frame buffer (X3768A/A-A) z Second monitor (X7128A/AA/AJ, X7128B) To use PGX32 frame buffer (X3668A/A-A, X3668B/B-A/B-B), the following patches are required to be insta ...

No Recommended actions Remarks For growfs(1M), the following patch is required to be installed. 120254-02 or later SunOS 5.10: ufs Patch 5 Install the above patches. Solaris 10 3/05 and 1/06 only When using any of the following PGX cards and monitors, the display monitor does not enter standby mode if you haven’t logged on from CDE (Common Desktop Environment). z PGX frame buffer (X3660A) z PGX64 frame buffer (X3768A/A-A) z Second monitor (X7128A/AA/AJ, X7128B) To use PGX32 frame buffer (X3668A/A-A, X3668B/B-A/B-B), the following patches are required to be insta ...