Kenmore 1340 Owner's Manual

2 - 3 Parts list................................................................ 4- 5 Setting up your machine ................. :........................... 6 Spool pins, Foot control, Light/power switch Installing extension table .......................... ...

==1. KNOWING YOUR SEWING MACHINE MACHINE IDENTIFICATION IIII IIIIII IIIII O ®. ® ® ® @ @ @ @ @ Model 1358 2 ...

IIII III Model 1595 ® .@ 1. Top cover 2. Bobbin winder tension disc 3. Thread guide 4, Pressure regulator 5. Take-up lever 6. Face cover 7, Face cover thread guide 8, Top thread tension control 9. Guide pin 10, Extension table 11. Support leg 12, Guide pin 13. Spool pins 14. Bobbin winder 15. Stitch selector 16. Reverse stitch l ...

I PARTS LIST IIIIIII PARTS AND ACCESSORIES PROVIDED WITH MACHINE 1 8 2 4 10 11 6 12 13 19 OPTIONAL ACCESSORIES 24 25 26 30 31 15 20 21 16 27 28 32 33 23 29 34 4 ...

parts and accessories,) All parts listed herein may be ordered from any Sears, Roebuck and Co. store or service center. WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE FOLLOWING INFOR- MATION: 1. PART NUMBER 2. PART DESCRIPTION 3. MODEL NUMBER shown on the nomen- clature plate. (See page 3 for location.) 4. NAME OF ...

sewing machine in a Kenmore cabinet, case or set the machine on a sturdy flat surface. 2. Your Kenmore sewing, machine has been throughly oiled at the factory. Be sure to wipe off the needle plate area, bed plate and bobbin case carefully before sewing ...

I I IIIIIIIIIIIIIIIIIIIIIII IHIIIIIHI I WINDING BOBBIN O ® ® i I i t ® ® !. Release clutch by pulling hand wheel or turning clutch knob toward you. 2. Draw thread from spool through bobbin winder tension disc as shown. 3. Pull end of thread through hole in bobbin as shown. 4. Push bobbin winder shaft to far left position, if it is not a ...

table from machine 5. by pulling it to the left. 6. 3. Open shuttle cover. To remove bobbin case from shuttle, pull open latch of bobbin case. Pull bobbin case straight out of shuttle. Release the latch and bobbin wilt ...

I HI I II ® , * 3. 4. With the bobbin case in your left hand, place the bobbin into it with the thread running clockwise. Feed the thread through the slot in the case. Pull the thread under the tension plate. Draw 3 to 4 inches of thread from bobbin, INSERTING BOBBIN CASE INTO SHUTTLE i With locating pin straight ...