Garmin c340 Quick Reference Manual

and other important information. Step 1: Mount Your c340 To ensure a tight grip, clean and dry the windshield before mounting the suction cup. 4 4. Fit the bottom of your c340 into the cradle of the suction cup mount. 5. Tilt your c340 back until it snaps in place. Tension knob 5 1. Plug the small end of the cable into the mount and the other end in a 12-Volt receptacle in your vehicle. 2. Place the suction cup on the windshield. 3. Flip the lever back, toward the windshield. 2 3 1 If necessary, use the tension knob to improve your viewing angle. Warning: This product contains a non-user-replaceable lithium-ion battery. Do not remove or attempt to remove the battery. Doing so could result in risk of battery fire or damage and injury. To prevent damage and risk of fire due to high temperatures, remove the unit from the vehicle or store it out of direct sunlight. For more information, see www.garmin.com/ safety.

Garmin®, StreetPilot®, and c340® are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. Step 2: Configure Your c340 Press and hold the Power button on the side of the unit to turn it on. Follow the on-screen instructions to set up your c340; you only have to do this once. Step 3: Find Your Destination ➍ Touch Go. ➋ Select a category. ➌ Select a destination. ➎ Enjoy the route! ➊ Touch Where to. Check your state and local traffic laws before mounting. Currently, state laws in California and Minnesota prohibit drivers from using suction mounts on their windshields while operating motor vehicles. Other Garmin dashboard or friction mounting options should be used.

Follow the route to your destination using the Map page. As you travel, your c340 guides you to your destination with voice prompts, arrows on the map, and directions at the top of the Map page. If you depart from the original route, your c340 recalculates the route and provides new route instructions. A checkered flag marks your destination. Follow the arrows as you take turns. Your route is marked with a magenta line. You can add a stop to your route. The c340 gives you directions to the stop and then to your final destination. 1. With a route active, go to the Menu page, and touch Where to. 2. Search for the extra stop. 3. Touch Go. 4. Touch Yes to add this stop before your destination. Or, touch No to make this your new final destination. Note: You can add only one stop to your route.

Map Page From the Menu page, touch View map to open the Map page. The position icon shows your current location. Touch buttons on the Map page to see additional information. Touch to zoom in. Touch the directions bar to open the Current Route page. Touch Turn In to open the Next Turn page. Touch Menu to open the Menu page. Touch Arrival or Speed to open the Trip Information page. Touch to zoom out.

➊ After you have found a place you want to save, touch Save. ➋ Touch OK. The place is saved in My Locations > Favorites. Finding Saved Places ➊ From the Menu page, touch Where to. ➋ Touch My Locations > Favorites. ➌ Select a place. Saving Your Current Location ➋ Touch My Locations. ➌ Touch Save > Yes. ➊ Touch Where to.

➊ Touch Where to > My Locations. ➌ Select an option. ➋ Touch Set Home. Going Home After you have set your Home location, you can route to it at any time by touching Where to > My Locations > Go Home. Traffic Information with an FM TMC Traffic Receiver Using a Garmin FM TMC Traffic Receiver, your c340 can receive and use traffic information broadcast over the FM Radio Data System. For more information about Garmin FM traffic receivers, visit www.garmin.com/traffic. Viewing Traffic Incidents From the Menu page, touch to display a list of traffic incidents. The traffic symbols appear on the Map as well. Avoiding Traffic The Map page displays when there is a traffic incident on your current route or on the road on which you are traveling. To avoid a traffic incident, touch , select a traffic incident, and touch Avoid.

To adjust the volume, turn the Volume knob, located above the Power button. Adjusting the �%D�N������ Backlight Brightness 1. From the Menu page, touch . 2. Touch to decrease the backlight brightness. Or, touch to increase the brightness. 3. Touch OK. Resetting Your c340 If your c340 stops responding, turn it off and back on. If this does not help, reset the c340. 1. Unplug the power and USB cables to remove external power. 2. Place your thumbnail in the groove located under the Garmin logo on the faceplate and gently pull off the faceplate. 3. Press the Reset button for about 3 seconds. 4. Connect the c340 to a power source using the power cable. The c340 should automatically turn back on and operate normally. More Information For more information about your c340, refer to the owner’s manual located at on Garmin’s Web site at www.garmin.com/products/sp340. Click on the Manuals link and then select Download. © Copyright 2005–2007 Garmin Ltd. or its subsidiaries July 2007 190-00437-01 Rev. D Volume knob Power button Mini-USB connector