Sharp AL-1600 Operation Manual

2 Open the bypass tray. Lift slightly on the side cover and slide the cover out until it stops. 3 Gently lift and pull out the paper tray and take the charger cleaner out by holding the tab. 4 Set the charger cleaner onto the transfer charger and gently slide the cleaner in the direction indicated by the arrow two or three times. Slide the charger cleaner from one end to the other end along the groove of the transfer charger. If the cleaner is stopped on the way, smudges on copies may occur. G ...

) indicator will blink. If paper is accidentally torn during removal, be sure to remove all pieces. Be careful not to damage the photoconductive drum. Misfeed removal Misfeed in the bypass tray 1 Gently pull the misfed paper out. 2 Lift slightly on the side cover and slide the cover out until it stops. Close the side cover by pressing the handle on the cover. G The misfeed ( ) indicator will go out. Misfeed in the copier 1 Open the bypass tray. Lift slightly on the side cover and slide the cover out ...

! 5 Drum cartridge handle Hold to pull out the drum cartridge. ! 6 Drum cartridge Copy images are formed on the photoconductive drum. ! 7 TD cartridge lock release lever Use to unlock the TD cartridge. ! 8 TD cartridge strap Lift to remove the TD cartridge. ! 9 TD cartridge Contains toner. @0 Roller rotating knob Turn to remove misfed paper. !5 !6 !7 !8 !9 @0 @1 @2 Part names and functions GETTING STARTED @1 Fusing unit release levers Lower to remove misfed paper. The fusing unit is hot. Take care in removing paper. @2 Pape ...

removed in step 5 and the screw which has been removed in step 2 in the front of the paper tray. G To store the pressure plate lock, rotate the lock to fix it on the relevant location. 7 Ensure that the power switch of the copier is in the OFF position. Plug the power cord into the nearest outlet. If you use the copier in a country other than the country where the copier was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the co ...

TD CARTRIDGE REPLACEMENT 5 Remove the protective cover from the TD cartridge by unlatching three cover hooks from the holes on the cartridge and then pulling the cover in the direction indicated by the arrow in the illustration. 6 Gently insert the TD cartridge along the guides until it locks in place. If dirt or dust is adhered to the TD cartridge, remove it before installing the cartridge. 7 Close the front cover by pushing both sides with your hands and then close the side cover by pressing the handle on the cover. The indicator will go out . ...