GBC 930-028 Operating And Maintenance Manual

iv © GBC Pro-Tech 1999 April Encapsulation ................................................................................................................. 3-7 Setup .......................................................................................................................... 3-7 Procedure ................................................................................................................... 3-7 Two-Pass Mount and Laminate (Hot and Cold) .............................................................. 3-7 Setup .................... ...

© GBC Pro-Tech 1999 April 1-1 6HFWLRQ   6DIHW\ Your safety, as well as the safety of others, is important to GBC Pro-Tech. This section contains important safety information. The following symbols are used throughout this man- ual to indicate warnings and cautions. DANGER WARNING CAUTION The F-60+ Laminator has been designed with safety as a primary consideration. However, you must become thoroughly familiar with the controls, proper operation, proper service procedures, and safety features of the laminator before using or servicing the unit. GBC Pr ...

Operation © GBC Pro-Tech 1999 April 3-15 352&(66&21752/&+$57% Product:____________________ Process: Cold Mount & Laminate (Second Pass) Date:________________ 352&(66&21752/',$*5$0% Cold Mount and Laminate (Second Pass)  NOTE Use footswitch to load, then accelerate materials through rolls. FRONT CONTROL SETTINGS Speed: 0-6 fpm (0-180 cpm) Reverse/Forward: Forward Roll Pressure: Trial Top Heater: 32-105 °F (0-40 °C) Cooling: Off Bottom Heater: 32 °F (0 °C) Hold Encapsulated Image Release Liner (Peel prior to nip) Foam Core  OPTIONAL Board ...

3-8 © GBC Pro-Tech 1999 April 3URFHGXUH 3DVV  1. Prepare to put the print through a second time to mount the print to the substrate - anything from wood, to Masinote, to Gator foam. Start by setting the shims to the appropriate spacing for the mate- rial used. 2. Trim the board to the size of the print. 3. Align the work to the board and ensure an exact fit. Place weights on the center of the print to make sure that it does not move relative to the board dur- ing the next steps. 4. Raise one end of the print and peel back approxi- mately two ...

2-4 © GBC Pro-Tech 1999 April 8QSDFNLQJ  NOTE ALL SHIPMENTS ARE EX- WORKS. At our dock title passes to the buyer. Please review your insurance cov- erage prior to shipment, as you are responsible for all subsequent freight charges and risks. Before signing the Bill of Lading you should be sure to inspect the crate and/or pallet for signs of damage or missing items; if applicable, make a note of this on the Bill of Lading. The F-60+ Laminator is shipped in a wood crate on a skid. WARNING Tools required: • Phillips head screwdriver • Adj ...