Sharp DK-A1H Quick Start Manual

System connections MUSIC SYSTEM FOR iPod® Wall socket (AC 220 - 240 V, 50 Hz) To AC input AM loop aerial x 1 Remote control x 1 FM aerial x 1 Turn on your system The first time the unit is plugged in, the unit will enter the demonstration mode. 1 Press the ON/STAND-BY button to turn the power on. AM loop aerial FM aerial AC power lead x 1 iPod adaptor x 8 Before using remote control Battery holder Plastic shield Remote controller Before using remote control, please remove plastic shield at battery holder. DK-A1H DK-A1H(BK) This quick Start Guide will help you to correctly install and operate your system. Illustration printed in this quick guide are for the model DK-A1H. MODEL 1 Whilst pushing the locking tab towards the centre of the remote control, slide out the battery holder. 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. Use the “CR 2025”, coin lithium battery. Remote control battery installation Back of remote control Locking tab Positive (+) side up Battery holder Polarity (+) symbol Battery type Locking tab TV Video Cable (not supplied) To video input socket

1 Push the iPod sliding door until end. 2 Insert the iPod adaptor into unit and connect your iPod. Listening to the radio 1 Press the ON/STAND-BY button to turn the power on. 2 Press the TUNER button on main unit or FUNCTION button on remote control repeatedly to select the desired frequency band (FM or AM). 3 Press the TUNING (44444 or 33333) button on the remote control to tune in to the desired station. Manual tuning: Press the TUNING (44444 or 33333) button as many times as required to tune in to the desired station. Auto tuning: When the TUNING (44444 or 33333) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station. H HH HH To remove iPod adaptor Hold this tip and pull as direction shown to remove adaptor. H HH HH iPod playback 1 Press the ON/STAND-BY button to turn the power on. 2 Press the iPod button on main unit once or FUNCTION button on remote control repeatedly to select iPod function. 3 Open the iPod terminal door and insert iPod unit in iPod dock of main unit. EQ - + iPod AUX E SOUN 4 Press the 0 0 0 0 0 / 6 6 6 6 6 button to start playback. iPod iPod adaptor Note: For details, refer iPod adaptor table on page 14 in the operation manual. Listening to the iPod EQ - + iPod AUX EQ - + iPod AUX E SOUN E SOUN E SOUN iPod (bottom) Dock connector iPod dock iPod connector iPod adaptor iPod