Sharp DK-AP2 Quick Start Manual

1 Whilst pushing the locking tab towards the centre of the remote control, slide out the battery holder. 2 Remove the old battery from the battery holder, insert the new battery and then slide the battery holder back into the remote control. Remote control battery installation Back of remote control Battery holder Locking tab Positive (+) side up Polarity (+) symbol Battery type Locking tab Accessories Remote control x 1 AC/DC adaptor x 1 RADPAA039AWZZ (DK-AP2) RADPAA036AWZZ (DK-AP2(BK)) AC power lead x 1 iPod adaptor x 8 Before using remote control Battery holder Plastic shield Remote control Before using remote control, please remove plastic shield at battery holder. Use the “CR 2025”, coin lithium battery. DK-AP2 QG 7/25/07, 1:38 PM 1 TINSEA197AWZZ 07G R MW 2 DK-AP2 This quick Start Guide will help you to correctly install and operate your system. Illustration printed in this quick guide are for the model DK-AP2. MODEL

AUX IN VIDEO OUT DC IN 6V AUX IN VIDEO OUT AC/DC Adaptor Cable DC INPUT socket (DC 6V) AC Power Lead AC/DC Adaptor Wall Socket (AC 110 - 240 V, 50/60 Hz) - VOL + ON/STAND-BY MUS IC S YS TE M DK - A P 2 H HH HH To remove iPod adaptor Insert the tip of a screwdriver (“–” type, small) into the iPod adaptor hole as shown and lift upward to remove. H HH HH iPod playback Note: Do not connect the Audio cable to AUX IN socket during iPod playback. Otherwise, sound from the iPod will not be heard. 1 Press the ON/STAND-BY button to turn the power on. 2 Insert iPod unit in iPod dock of main unit. Press the 0 0 0 0 0 / 6 6 6 6 6 button if the iPod unit is in pause mode to start playback. H HH HH To disconnect iPod Simply remove the iPod from the iPod dock. It is safe to do so even during playback. Power source Listening to the iPod H HH HH To insert iPod adaptor 1 Insert the iPod adaptor into unit and connect your iPod. iPod (bottom) Dock connector iPod dock iPod connector iPod adaptor iPod - VOL + ON/STAND-BY MUS IC S YS TE M DK - A P 2 iPod iPod adaptor Press the ON/STAND-BY button to turn the power on. The POWER indicator turns blue to indicate power on. Turn on your system - VOL + - ON/STAND-BY - MUS IC S YST EM DK-A P2 ESOUND STAND-BY H HH HH Using with the batteries 1 Disconnect the AC/DC adaptor, and open the battery compartment. 2 Insert 4 “AA” size batteries (UM-3, R6 or similar) into the battery compartment. 2 + + + 3 4 + 1 3 Close the battery compartment. 4 The STAND-BY indicator will turn red. Remove the batteries if the unit is not to be used for long period of time to prevent battery leakage which may cause potential damage. When using batteries, the brightness of all illumination light (indicators) is reduce compared to using AC/DC adaptor. H HH HH Using with the AC/DC adaptor 1 Plug the AC power lead into the AC/DC adaptor. 2 Plug the AC/DC adaptor cable into the DC Input socket on the unit. 3 Plug the AC power lead into a wall socket and switch on the power supply. The STAND-BY indicator turns red and when the power is on, the POWER indicator turns blue. DK-AP2 QG 7/25/07, 1:38 PM 2