Sharp FO-2150CM Technical Manual
Text of the manual
1 - 1
UX-2200CMU/CMC
FO-2150CMU/CMC
FACSIMILE
INK JET PRINTER
UX-2200CM
MODEL FO-2150CM
No. 00ZU220CMUTME
TECHNICAL MANUAL
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
This document has been published to be used
for after
– 1 –
[1] Engine Specifications
1. Mechanism
Resolution
: 600 dpi x 600 dpi addressability
Print Speed
: 3 PPM draft text with black cartridge
Print Swath
: 8 inches
Duty Cycle
: Up to 500 pages per month maximum, 170 pages per month average
Dimensions (approximate) : 350mm x 125mm x 60mm
Weight (approximate)
: 1.2 pounds
A
[4] Circuit description
1. General description
The compact design of printer PWB is obtained by using 8 bit microprocessor(CPU) and ASIC in the printer control
section.
2. Electrical System
The PWB provides mechanical control for Ink Jet Printer.
Figure 1 shows the interconnection of PWB and other electrical component in the pri
3. Electricai Overview
The information in this section appears in a sequence relative to the system diagram in the following figure.
4. Power Supply Connector
The mechanism requires two voltages (+5V and +24V).
These two voltages supplied from CNPRT connector.
5. Host interface connector
Connector CNPRT on the printer PWB provid
7. Driver IC
The paper motor and carriage motor require current that cannot be driven directly from ASIC chip.
Motor driver IC provide the additional current and voltage capability.
The driver IC (IC1 and IC2) located near the respective motor connector on the printer PWB also connect back to the
ASIC.
Two additional drivers IC
