Rockford Fosgate RFX-8115 Operation & Installation

Source Unit Mounting Angle • Mount the Installation Sleeve into a secure instrument panel • Bend Tabs on the installation sleeve which correspond to the chart above • Bend Appropriate Tabs on all sides of the mounting sleeve (Top, Bottom, Left & Right) 20° 20° • Mount the Source Unit as close to horizontal as possible for optimum CD Player performance • Mounting Angles up to ±20° from horizontal can be accommodated Mounting the Installation Sleeve Instrument Panel Thickness Tabs to Bend A B C D E F G 1.2mm to 2.5mm x x x 2.4mm to 3.5mm x x x 3.6mm to 4.5m ...

sequentially sample each preset tuner frequency for five seconds each. (Up to 18 FM or 6 AM presets) Preset Scan Select Press the P.SCN button to enable Preset Scan mode. If a preset station is active when P.SCN is depressed, then the preset stations will be sampled sequentially beginning at the next higher numbered preset. Preset Scan Cancel Press the P.SCN button a second time to cancel the Preset Scan mode. It is also canceled by all buttons except LOUD, EJECT and audio volume functions. Display During Preset Scan tuning, the display wi ...

The Source Units utilize a refined high performance tuner for provid- ing unmatched tuning range. The tuner uses a patented Digital Automatic Alignment (a mini pre-programmed computer) to pre- cisely target and “tune in” FM radio stations. The aftermarket standard is done by mechanical alignment which relies on not-so-precise tunable inductors to “get within the ballpark” of a radio station. The tuner is also refined with Dual FM Conversion and Dual AM Up- Convert schemes to create a tuner that is capable of receiving radio signals better. THE RESULT: Absolutely ...

DO NOT touch the playing side (opposite of label side) of the disc. When handling the disc, only the outer edges or center hole of the disc should be touched. DO NOT affix any sticker or label on the disc. DO NOT apply vinyl record spray, anti-static agent, acetone, or any other volatile chemicals to the disc. Damaged Disc DO NOT play a cracked, warped or damaged disc. Doing this may cause serious damage to the play- back mechanism. New Discs The CD player will eject discs that have either been inserted incorrectly or have irregular surfaces. If a new disc ...

Turn On “C” does not work Tuner cannot “tune-in” any radio stations Tuner has poor reception Disc will not load into Source Unit (also see error codes) Pulsed Output accessible only through “Diamond R” button on IR Remote Blue/Red wire discon- nected IR Remote is not operat- ing properly External relay system not operating properly or draws more than 300mA Antenna is disconnected Antenna is disconnected or not properly grounded to vehicle Antenna cable is inter- mittent or damaged Antenna is wrong type for AM/FM frequencies Voltage applied to Red and Yellow wires is not ...

radio tuner and go to the last active band. 2. Consecutive pressing of the SINE WAVE (tuner) button cycles the radio through FM1, FM2, FM3 and AM. Display The display will indicate “TUNE,” station frequency, and band indicator for five seconds. After five seconds, the display will switch to its default (Tuner or Clock). Initial Power-Up Defaults – Americas Preset Preset Preset Preset Preset Preset 1 2 3 4 5 6 FM1 (MHz) 87.75 88.1 98.1 96.3 107.9 103.7 FM2 (MHz) 87.75 88.1 98.1 96.3 107.9 103.7 FM3 (MHz) 87.75 88.1 98.1 96.3 ...

Weltweiter Tuner Das Frequenzband des Tuners kann programmiert werden, um in den verschiedenen Ländern einwandfrei zu funktionieren (ausgenommen Japan). 1.Drücken und halten Sie DSPL für zwei Sekunden 2.Drücken Sie SINE WAVE (Tuner) 3.Drücken Sie SEL, um zwischen AMERICAS, EUR/AUST und SAUDI umzuschalten Tuner Einstellung – AM>FM1>FM2>FM3 1.Drücken Sie SINE WAVE (tuner), um die Tuner-Einstellung aufzurufen 2.Drücken Sie SINE WAVE (tuner), um zwischen FM1, FM2, FM3 oder AM auszuwählen Sender-Festeinstellung 1.Suchen Sie die Station, die gespeichert werden soll 2.D ...