Graco 288466 Instructions Manual

tion point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. Refer back to these warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable. WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or tempera ...

minimum prior to assembly. Note: For steps 8-10 refer to Fig. 12. 8. Place male gland (20) in cylinder. 9. Alternately stack UHMWPE (21) and leather pack- ings (22). Note orientation. 10. Place female gland (23) in top of cylinder. Seat packings. FIG. 12 11. (Fig. 13) Install packing nut (3) into cylinder and hand tighten. FIG. 13 12. (Fig. 14) Install o-rings (14) inside cylinder (2) and on sleeve (4). Slide sleeve (4) into bottom of cylinder (2). Replace o-ring (15) if desired. FIG. 14 Note: O-ring (15) is not required f ...

1. Engage trigger lock. 2. Turn engine ON/OFF switch to OFF. 3. Move pump switch to OFF and turn pressure control knob fully clockwise. 4. Unlock trigger lock. Hold metal part of gun firmly to side of grounded metal pail and trigger gun to relieve pressure. 5. Engage the trigger lock. 6. Open all fluid drain valves in the system, having a waste container ready to catch drainage. Leave drain valve(s) open until you are ready to spray again. If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after follo ...

minimum prior to assembly. Note: For steps 8-10 refer to Fig. 12. 8. Place male gland (20) in cylinder. 9. Alternately stack UHMWPE (21) and leather pack- ings (22). Note orientation. 10. Place female gland (23) in top of cylinder. Seat packings. FIG. 12 11. (Fig. 13) Install packing nut (3) into cylinder and hand tighten. FIG. 13 12. (Fig. 14) Install o-rings (14) inside cylinder (2) and on sleeve (4). Slide sleeve (4) into bottom of cylinder (2). Replace o-ring (15) if desired. FIG. 14 Note: O-ring (15) is not required f ...

1. Stack male gland (7) on piston rod (5). 2. Alternately stack blue UHMWPE (8) and brown UHMWPH (9) (288466, 288467, 2884680) or leather (288819) packings on piston rod. Note orientation. 3. Install female gland (10). 4. Install backup washer (13) and piston wiper (12) on piston valve (6). Note orientation. The special sealing patch on piston valve threads is good for 4 repackings. Use Loctite® on piston valve threads after 4 repackings. FIG. 9 5. (Fig 10) Install ball (11) in piston rod (5). If Loctite® is applied to piston v ...