Grundig LE 7940 Operation & User’s Manual

2 ------------------------------------------------------------------------------------------------------------------------------------------------------------------ A G H C I B C J E D F

3 ------------------------------------------------------------------------------------------------------------------------------------------------------------------ TÜRKÇE ??-?? DEUTSCH 4-17 ENGLISH 18-30 FRANÇAIS 31-43 ITALIANO 44-56 PORTUGUÊS 57-69 ESPAÑOL 70-82 POLSKI 83-95 ČESKY 96-108 MAGYAR 109-121 TÜRKÇE 122-134 ΕΛΛΗΝΙΚΑ 135-147

tions when using the appliance: 7 This appliance is designed for domestic use only. 7 This appliance is designed for the removal of human body hair. Any other use is expressly pro- hibited, particularly for the re- moval of hair on the head. 7 Do not immerse the appliance in water. 7 Only use the KG3B-030-1000D power supply unit provided. 7 Do not drop the appliance. 7 Disconnect the power supply unit after use or charging. 7 Never use the appliance if it or the power supply unit show signs of damage. 7 Do not use the appliance if you have varicose veins. 7 Removing hair from the roots can cause reddening or irrita- tion of the skin. This is a normal reaction and only lasts a short time. If irritation persists longer than three days, consult your doctor. 7 We recommend epilating in the evenings. This gives any skin irritations that might occur a chance to wear off overnight. 7 To avoid accidents, keep the ap- pliance away from the hair on your head, eyebrows and eye lashes, and also from clothes, brushes, wires, cords, laces, etc. 7 Keep the appliance out of the reach of children. 7 If the power cord from the charging unit is damaged, it must be replaced by the manu- facturer, its service centre or a similarly qualified person to pre- vent danger arising.

by the following people, includ- ing children: those with limited physical, sensory or mental ca- pabilities and also those with a lack of experience and knowl- edge. This does not apply to the latter if they were instructed in the use of the appliance or if they use it under the supervision of a person responsible for safety. Children should always be supervised to ensure that they do not play with the appli- ance. 7 Do not open the appliance under any circumstances. No warranty claims are accepted for damage caused by improper handling.

of your LE 7940 epilator. Read the following user notes carefully to ensure you can enjoy your quality product from Grundig for many years to come. Special features – Your appliance is suitable for any type of skin. The patented, innovative rotating head re- moves even the shortest of hairs of 0.5 mm or more. – The device will remove your hair right down to the root for four to six weeks. – To prepare for epilating, you can trim longer hairs with the replaceable shaving head. – The replaceable shaving head enables the appliance to also be used as a lady shaver, which is ideal for sensitive areas such as the armpits or bikini zone. Controls See the illustrations on page 2. Protective cap. Epilator head with rotating part. Side catches. These open the catch for removing the epilator or shaving head. Switch for switching on and off, and for selecting the two speed settings. Charging display. Power cord socket. Blade foil. Shaving head. Accessories Power supply unit. Cleaning brush. J I H G F E D C B A

with the built-in nickel metal hydride battery, only use the power unit supplied for charging. Check if the type plate on the power supply unit corresponds to your local mains supply. 1 Press the button to switch off the appliance. 2 Plug the power cord into the ap- pliance socket and the power supply unit into the wall socket. – During the charging process, the display lights up red. – Once the appliance is fully charged, the charging display does not switch off or change its colour. 3 Pull the power cord out of the the appliance socket and the power supply unit out of the wall socket. E F F D Notes 7 Charge up the batteries com- pletely (for at least 12 hours) be- fore you first use them or if you have not used them for a long time. 7 Never charge the appliance for longer than 24 hours. 7 The ambient temperature should be between 5 °C and 40 °C. 7 Once you have used the appli- ance, charging time is approx. 8 hours. 7 In its fully charged state, the ap- pliance can run for approx. 60 minutes. It is not advisable to charge the batteries after each use. Only charge the batteries when they are completely dis- charged. This increases their service life. Do not charge them every day.

the power supply unit provided. Check that the voltage indicated on the type plate of the power sup- ply unit corresponds to your local power supply. The only way to disconnect the ap- pliance from the power supply is to unplug the power supply unit. 1 Insert the power cord into the socket on the appliance. 2 Plug the power supply unit into the power socket. I F Caution 7 Only use the appliance in battery mode when in the bathroom or beside a water connection; never run it from the mains.

are longer than 10 mm, it is advis- able to trim these with the shaving head beforehand. Caution 7 The shaving head can only be used with speed setting »1«. 1 Press the button to switch off the appliance. 2 Remove the epilator head . To do this, press the side catches and take off the epilator head with the other hand. C B D 3 Attach the shaving head and press it down until it latches in place. 4 Insert the power cord into the socket on the appliance and plug the power supply unit into the mains socket. 5 Switch the appliance to position »1« using . 6 Trim hairs by moving the appli- ance gently over the parts of skin. F I H D

warm bath or shower to open the pores. This way your skin will be clean and smooth and thus in the best condition for epilating. Make sure your skin is clean, not greasy and completely dry before epilating. 1 Remove the protective cap from the appliance. 2 Press the button to switch on the appliance. 3 Adjusting the speed. – Low (»1«) for fine hair. – High (»2«) for coarser hair. D A 4 We recommend holding the ap- pliance in your hand at a 100° angle to your skin. Do not exert any pressure, just touch the skin. Warning 7 Do not use the appliance on moles or birthmarks. Birth- marks should never be scratched, ruptured or de- pilated. If this is the case, your health could be at risk.

if you were brushing or wiping – in the direction the hair grows. 6 Pull the skin taut with your other hand, if necessary. Stretch out your leg when removing hair be- hind your knee. 7 You can also remove hairs on your thigh or bikini area. 8 You can remove individual hairs on your top lip or cheek. 9 Hold out your arm to stretch the skin when removing armpit hairs. Note 7 If you have not removed the hairs from your bikini area or under your armpits for a longer period, start by trimming them with the replaceable shaving head . 10 Press the button to switch off the appliance after use. 11 Disconnect the power supply unit from the wall socket. D H

ance, it may feel slightly un- pleasant, as you are removing hairs by the roots. This feeling subsides after several uses, even if you have sensitive skin. 7 The first time you use the epila- tor, the results will last four to six weeks. After each further use, your hair will grow slower and thinner. 7 Hold the appliance with a re- laxed and comfortable grip. Do not exert any pressure. For your safety, the appliance slows down or stops rotating if you press too hard on your skin. 7 If you have varicose veins or other health problems, you must consult your doctor before use. 7 For reasons of hygiene, the ap- pliance may only be used by one person.

Cleaning the epilator head 1 Turn the appliance off and un- plug the cable. Pull the power supply unit out of the mains socket. 2 Remove the epilator head . To do this, press the side catches and take off the epilator head with the other hand. C B 3 Use the cleaning brush supplied to remove all hairs from the mechanism, the housing and the appliance. 4 Put the epilator head back on again. Push down the head until it catches. Note 7 Note the position of the guide groove on the bottom of the epi- lator head housing. It must be aligned with the guide slot on the appliance housing. 5 Replace the protective cap . J A

Note 7 You do not have to clean the discs of the epilator mechanism. However, to maintain hygiene, you can wipe them from time to time with alcohol. Use a cotton bud which you have first soaked in alcohol and then squeezed out. The cotton bud must not be wet. Caution 7 Never hold the appliance in wa- ter or any other liquid. 7 Do not use any household cleaning agents. Cleaning the shaving head 1 Turn the appliance off and un- plug the cable. Pull the power supply unit out of the mains socket. 2 Remove the shaving head. To do this, press the side catches and take off the whole shaving head with the other hand. 3 Remove the blade foil from the shaving head by pulling the part up. 4 Knock the bottom of the blade foil gently against a flat surface. G G C

Caution 7 Never clean the blade foil of the shaving head with the cleaning brush supplied. 5 Clean the bottom of the shaving head with the cleaning brush supplied . 6 Insert the blade foil in the shaving head again. 7 Put the shaving head back on again. Push down the shaving head until it catches. J Storage If you do not want to use the appli- ance for a long period of time, please store it carefully. 1 Ensure that it is switched off and is dry. 2 Ensure that the epilator head and the shaving head are com- pletely clean. 3 Store the appliance, the shaving head and the power supply unit in a cool, dry place. 4 Make sure the appliance is kept out of reach of children.

high-quality parts and materials which can be reused and recycled. Therefore, do not dispose of the product along with normal house- hold waste at the end of its service life. Take it to a collection point for the recycling of electrical and elec- tronic equipment. This is indicated by this symbol on the product, in the operating manual and on the packaging. Please find out about collection points operated by your local authority. Help protect the environment by recycling used products. Technical data This product con- forms to the Euro- pean directives 2004/108/EC and 2006/95/EC. Power supply Power supply unit KG3B-030-1000D 230 V ~, 50 Hz Batteries: Nickel metal hydride Technical and design modifica- tions reserved. Ni-MH

Atrium, Strawinskylaan 3105 • NL-1077 ZX Amsterdam • http://www.grundig.com 72011 905 1500 Cat. No.: 74154400