Haier HR-60A Operation Instructions Manual

flooring. If the appliance is to be placed on a soft carpet, support the appliance with a solid wood board. If the appliance is placed on the carpet directly, the high-temperature compressor may cause color fading of the carpet. A separate earthed three-pole is required. Stop using the appliance if a sensation of electric shock is felt when touching the refrigerator. The appliance must be properly earthed, especially in a place of thick moisture. 1. Clean the inner compartment. 2. A special socket is required. 3. After 2 or 3 hours of non-load operatio ...

can solve the problem yourself. Problem Possible Causes No refrigeration Electrical connection is loose. Fuse is broken. Wrong temperature selection. The inner compartment is overfilled. The appliance is exposed to direct sunlight or a heat source, such as heater. Frequent door opens. The appliance doesn’t stand level. Some part of the refrigerator rubs against the wall or other furniture. It’s normal that the noise of flowing refrigerant can be heard during the interval of the stop and restart of the compressor. ...

4. Bottle rack 2. Ice tray 5. Shelf 3. Evaporator 6. Water tray The manufacturer reserves the right to improve the product from time to time without further notice. .3.





Parts ...

the refrigerator is working. When the frost layer is thick as 3mm, the refrigerator must be defrosted and cleaned. Otherwise, it may results in lower efficiency and high energy consumption. 1. Take out foods and ice tray. Keep the door open. 2. Set the temperature at ‘0’ position. After defrosting, dry the water tray and then replace it in the refrigerator. Reset the temperature regulator to its original position. Making ice Fill the 3/4 ice tray with water and then place it in the lower part of the evaporator. Set the temp ...

panel directly against the wall. For a good air circulation, the vent grille at the back of the worktop must not be blocked, It should be placed on flat and firm ground lest it gives off higher noise than usual. Do not expose the appliance to direct sunlight or a heat source as cookers, radiators, heaters, etc. Allow warm foods or beverages to cool down before placing them into the appliance. Do not open the door more often than necessary to lessen cold air escape. For adequate air circulation, do not overfill the refrigerat ...

the refrigerator is working. When the frost layer is thick as 3mm, the refrigerator must be defrosted and cleaned. Otherwise, it may results in lower efficiency and high energy consumption. 1. Take out foods and ice tray. Keep the door open. 2. Set the temperature at ‘0’ position. After defrosting, dry the water tray and then replace it in the refrigerator. Reset the temperature regulator to its original position. Making ice Fill the 3/4 ice tray with water and then place it in the lower part of the evaporator. Set the temp ...

must be properly grounded in accordance with specifications. Always remember to unplug the appliance before cleaning. Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet. All electrical repairs must be carried out by qualified electricians. Inadequate repairs may result in a major source of danger for the user of the appliance. Keep high-proof beverages in airtight bottles or containers and always store in an upright position. In addition, do not store any expl ...