Parkinson Cowan Renown RG50MG Operating And Installation Instructions

In the event of your appliance requiring service or if you wish to purchase spare parts please contact your local Service Force Centre by telephoning 0 8 7 0 5 9 2 9 9 2 9 Your call will be routed to your local Service Force Centre covering your postcode area. Customers in Ireland should telephone (01) 4090755 Before you call an engineer check through the information under the heading 'What is wrong and why? ' When you report a problem try to describe the nature of the fault. Always give your appliance's full name, model ...

Do not use any polishes, caustic cleaners, abrasives, washing soda or soap except those recommended. Please note: If we recommend you use hot soapy water we mean hot water with washing up liquid in it and not any other cleaning product. If you own a dishwasher please read the operating instructions for the machine before you wash any part of your appliance in it. Clean your appliance regularly using a cloth that has been wrung out in hot soapy water. Rinse and polish it dry using a soft cloth. When you remove parts of your appliance for cleaning do not plunge them into water ...

Do not use any polishes, caustic cleaners, abrasives, washing soda or soap except those recommended. Please note: If we recommend you use hot soapy water we mean hot water with washing up liquid in it and not any other cleaning product. If you own a dishwasher please read the operating instructions for the machine before you wash any part of your appliance in it. Clean your appliance regularly using a cloth that has been wrung out in hot soapy water. Rinse and polish it dry using a soft cloth. When you remove parts of your appliance for cleaning do not plunge them into water ...

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less than R³/8. Connection is made to the Rc½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT TAPE. Check for gas soundness after connecting the gas supply. The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3. Take into account that it must be possible ...

particularly useful when cooking soups, stews and casseroles because the long slow cooking will make cheaper, tougher cuts of meat more tender. You need to cook food at gas mark 6 for 30 minutes before you turn the oven down to a slow cook setting. This makes sure that the temperature of the food gets hot enough to start the food cooking. Some foods such as pastry and biscuits are not suitable for slow cooking because the temperature is too low. Cover all food during cooking to prevent it from drying out. You can uncov ...

Injector Marking 108 78 Flame Supervision Device Diamond'H' GSD 100/28 Diamond 'H' GSD-100-30 Thermostat Diamond'H' 1100157/B2 Diamond'H' 1100-98/B2 Thermostat By-pass Marking 69 78 GENERAL Ignition H. T. Spark Spark Gap 3-4mm IMPORTANT - SAFETY REQUIREMENTS This appliance must be installed in accordance with the Gas Safety (Installation and Use) Regulations Current Editions. Detailed recommendations are contained in the following British Standard Codes of Practice - BS. 6172, BS.5440: Part 2 and B.S.6891. All Brit ...

R G 5 0 M G 24 To prevent damaging or weakening the door glass panels avoid the use of the following: Household detergents and bleaches Impregnated pads unsuitable for non-stick saucepans Brillo/Ajax pads or steel wool pads Chemical oven pads or aerosols Rust removers Bath/Sink stain removers If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further. Care and cleaning ...