Harman Advance Freestanding Pellet Stove Installation & Operating Manual

3 Blinks: Indicates a poor ESP connection or that the ESP (Exhaust Sensing Probe) has gone out of range too many times. If the stove seems to be operating normally, perform a manual reset*. 4 Blinks: Can occur only in Room Temp Mode and indicates Room Sensing Probe failed or not installed. If a Room Sensing Probe is then installed, the status light will automatically reset. NOTE: Unit will not start in "AUTO" with this status error. 5 Blinks (In Igniter Auto. Mode Only): Indicates that the unit has failed to light after 4 consecut ...

in a mixture with wood pellets. The listing approves up to a 50% corn and 50% pellet mixture. Different mixtures of corn will have distinctively different burn characteristics depending upon moisture content and variety. The operator should closely monitor the stove’s operation when burning a new corn/pellet mixture or a different variety of corn, and make any necessary adjustments to feed rate. Since corn is typically higher in ash and moisture content, cleaning and ash remov ...

1" Manual Start Up 1. Fines are small pieces of broken pellets (sawdust). Fines do not flow easily and often build up on the hopper funnel bottom angles. These fines can be pushed into the feeder opening and then fill the hopper with pellets. As the system works, they will be burned. 2. The "TEST" cycle will operate the feeder motor for exactly one minute. Turning to "TEST" again and again may purge too much fuel into the burn pot causing excessive smoke on start-up. 3. The firebox low pressure switch will not allow the auger motor or the igniter ...

temperature of 70 degrees with the distribution blower at medium speed. This setting will produce a large viewing fire without a distribution blower operating. Manual Constant Burn Mode The Advance Pellet Stove is capable of manual operation. This also allows the operator to manually control operation during an emergency (i.e. igniter failure.) The unit can be switched between "AUTO" and "MANUAL" at any time during operation. NOTE: It is possible to start a fire in "Auto" and switch to "Manu ...

Ending manufacturing date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. hearth and home Technologies does not sell directly to consumers. Provide model number and serial number when requesting service parts from your dealer or distributor. Stocked at depot ITEm dESCrIPTION COmmENTS PArT NumbEr 3 Hopper Lid Assembly 3.1 Hopper Lid Latch (Male and Female) 2 Sets 1-00-0669697 Y 3.2 Hopper Lid 3-40-06693 Y 3.3 Hopper Knob Gold 1-00-02000 Brushed Nickel 1-00-02000-8 3.4 Hi ...

dimension may be used as long as they satisfy the measurement requirements shown below. Minumum size floor protection for a corner installation hearth pad is 36" x 36". Corner to edge dimension for corner installation floor protection = 47" / 1194 mm Floor Protection Floor Protection Floor Protection Consult with your local building code agency and insurance representative before you begin your installation to ensure compliance with local codes, including the need for permits and follow-up inspections. Several issues must be addressed when select ...

CAUTION: Surfaces are hot while in operation, Wear gloves to protect from burns. 1. Open side doors. Fig. 29 2. Release spring latches on the right and left side of the ash pan. Fig. 30 3. Slide ash pan forward enough to lift with center handle. Empty ashes and reinstall ash pan. Fig. 31 Disposal of Ashes: Ashes should be placed in a steel container with a tight fitting lid. The closed container of ashes should be moved outdoors immediately and placed on a noncombustible floor or on the ground, well away from all combustible materials, ...