Sony STR-DG520 Operating Instructions Manual

selected. However, "UNLOCK" appears on the display if no digital signal is input through the COAXIAL jack. Lights up when the receiver recognizes a component connected via a HDMI IN jack (page 17). The letters (L, C, R, etc.) indicate the channels being played back. The boxes around the letters vary to show how the receiver downmixes the source sound (based on the speaker settings). Front Left Front Right Center (monaural) Surround Left Surround Right Surround (monaural or the surround co ...

without any adjustment (ANALOG DIRECT) You can switch the audio of the selected input to two channel analog input. This function enables you to enjoy high quality analog sources. When using this function, only the volume and front speaker balance can be adjusted. Sound field 1 2 buttons 1 Turn INPUT SELECTOR on the receiver to select the input you want to listen to in analog audio. You can also use the input buttons on the remote. 2 Press ANALOG DIRECT on the receiver. The analog audio is output. To cancel ANALOG DIRECT Press ANALOG DIRECT on the receiver again. You can ...

Definition Multimedia Interface. It is an interface which transmits video and audio signals in digital format. Before connecting cables, make sure to disconnect the AC power cord (mains lead). - DVD player Blu-ray disc player TV, etc. Audio signals Audio/video signals Audio signals Audio/video signals Audio/video signals o Coaxial digital cord (not supplied) 49 HDMI cable (not supplied) We recommend that you use a Sony HDMI cable. e Optical digital cord (not supplied) continued------ 17US ...

selection is set to "YES" (page 37) and the audio signal is output from the SUB WOOFER jack. Lights up when the disc being played back contains an LFE (Low Frequency Effect) channel and the LFE channel signal is actually being reproduced. Lights up when the receiver is decoding Dolby Digital signals. Note When playing a Dolby Digital format disc, be sure that you have made digital connections and that INPUT MODE is set to "AUTO" (page 50). "0[] PL ...