Sony SRW-5000 Installation Manual

n No data can be read from the system bank in the standby mode or while a tape is loaded in the unit. Eject the tape and confirm that the standby mode is set to off before reading data. (1) Press the [F8] (DIRECTION) key with the SYSTEM BANK menu, and choose direction. The left cursor bar blinks. (2) Position the lighting cursor bar at a bank number (1 to 8) for reading with the [(]/[)] keys. (3) Press the [F9] (COPY) key. A confirmation message appears. To cancel reading Press the [CLR] (CLEAR) key while the confirmation message ...

Rail bracket fixing screws A = A' = 416 mm Hexagon socket head cap screw 2 pcs Hexagon socket head cap screw 2 pcs Hexagon socket head cap screw 2 pcs Hexagon socket head cap screw 2 pcs 2U Plate nut (small) Rail Flat washer Hexagon socket head cap screw L-shaped hexagon wrench By 5U . Attaching the outer rails 13. Loosely attach the two outer rails to the middle of the 5U space in the rack for mounting this unit, with the eight hexagon socket head cap screws, eight flat washers, and four plate nuts (smal ...

Board Switch No. Factory setting VPR-79 S100 S700 1 2 O N 3 4 1 2 O N 3 4 ...

156 32 32 12.7 123.8 34 263.5 415.9 457.5 42.5 (38.5) 218 37 465 482 220 20 149.2 364 31.5 427 533 45.5 538.5 416(Rail-installed width) 427(Unit width) Unit : mm (Mass of this unit : approx. 30 kg) Moreover, an air flow that is effective in cooling the unit is essential. If the ventilation is not enough, the unit may be damaged because of an increase of the internal tempera- ture. n This unit is air-cooled by the fans. The operation with the upper lid is removed affects the air cooling by the fans. Complete the work in a sho ...

29.97PsF, 30PsF 20 A0 00 96 07 07 03 8A 0D 06 00 00 80 3D FF 5A 21 A0 00 7D 07 07 03 8A 0D 06 00 00 80 3B FF 4B 50i, 50P, 25PsF 24PsF, 23.98PsF 22 A0 00 78 07 07 03 8A 0D 06 00 00 80 3B FF 4B Frame rate VTR CONSTANT 1 1 2 3 4 5 6 7 8 Data No. VTR CONSTANT 2 1 2 3 4 5 6 7 8 Data No. 1-14. Settings when Editor is Connected 1-14-1. Settings for Time Code To set the TIME CODE, use the TC menu in the function menu. Set the TIME CODE as follows when the editor or the VTR with edit function is connected. Button Item Setting F6 REGENE SOURCE int-L F7 TCG MODE prese ...

under the application. If the setting is changed temporarily by changing operating condition, the setting can be reset easily. For the setup menu, store the setting values to the Memory Stick (Memory Card) before check, mainten- ace and repair. (Refer to the operation manual.) It is recommended to attach the sheets to the unit when check, maintenance and repair. If the unit is used frequently by changing the combination of each system, making the sheets are conve- nient. (Make ...