HP 705 User Notes

User Notes Refer to your workstation owner’s guide or your disk drive installation guide for detailed information about installing your disk drive. During the installation procedure, you may have to change the SCSI ID of your disk drive. Refer to the appropriate illustration to set the SCSI ID jumpers to the desired SCSI ID. NOTICE: We recommend that you use SCSI ID 6 for your workstation’s first hard disk drive, and SCSI ID 5 for the second hard disk drive.          The 9–GB disk drive is fully operational with HP-UX Release 10.01 and later on Series 700 binary–compatible systems. The following patches are required to the operating system. HP-UX Version Patches – OS Patches – Diags 10.01 PHKL_8904, PHKL_8329 PHSS_7583 10.10 PHKL_8906 PHSS_7585 10.20 PHKL_8908 PHSS_7929 After you have loaded HP-UX onto the drive, install the appropriate patches using swinstall and reboot the system. Part Number A1658–90693 Edition E1196 Printed in U.S.A.
  

may receive an HP–UX Install Utility Message Dialog with the following error reported: ERROR: The disk at address “x/x/x.x.x” requires more than the current limit of 2000 physical extents (of size 4 mega- bytes (MB)) to completely allocate all its available space (8676 MB). You must either increase the physical extent size or increase the limit for maximum physical extents for the volume group “vgxx”. (See the “Modify Volume Group Parameters” screen.) Select Modify Configuration at the bottom of the mes- sages dialog. At the next screen, select Modify Volume Group Param- eters. At this screen you should change either the number of ex- tents or the size of the extents. A greater number of extents uses more in–core memory, but results in less file fragmentation on the disk. We suggest the following: If your system has 64MB or less of system RAM, increase the value for Physical Extent Size. If your system has more than 64MB of system RAM increase the value for Maximum Physical Extents. The HP part numbers for this drive are A1658–60016 (spare) and A1658–69016 (exchange). CAUTION NOT Do plugs for J2 on J6. You will damage the internal contacts use the jumper A2 A1 A0 0 1 2 3 4 5 6 SCSI J6 J2 M S B L S B ID A3 8 9 10 11 12 13 14 15 Highest Priority Lowest Priority No jumpers installed Seagate ST19171WD Disk Drive Jumpers