HP NetStorage 6000 Configurations
Text of the manual
Network Interface Upgrade
H
P
N
E
T
S
T
O
R
A
G
E
6
0
0
0
Configurations supported:
Any combination of one or two of the following
HP NICs is supported:
• 10/100 bT
• Dual 10/100 bT
• Gigabit 1000 Base SX
Each NIC port must be attached to a different subnet.
Trunking is not supported.
Parts required:
• New NIC card
Tools required:
• Phillips screwd
A. Unplug the network cable.
B. Unscrew the existing NIC and gently remove it.
NOTE: If you are installing the NIC in an unused PCI slot,
remove the expansion slot access panel.
A. Select an open PCI slot.
B. Gently place the new card in the slot, and screw it into
place.
A. Slide the top back into place.
B. Using the screwdriver, secure the top to the unit.
Connect the Unit
A. Connect a network cable to the new port(s).
B. Reconnect the two power cords on the back panel of the
HP NetStorage unit, and plug them into your power source.
C. Turn on the unit.
D. Press the alarm-reset button on the front panel to turn off
the alarm. The alarm sounds whenever the unit is powered on.
A. Follow one set of the dir
