Sub-Zero Freezer Operation & User’s Manual

As you follow these instructions, you will notice WARNING and CAUTION symbols. This blocked information is important for the safe and efficient installation of Sub-Zero equipment. There are two types of potential hazards that may occur during installation. Another footnote we would like t ...

millimeters unless otherwise specified. TO O L S A N D M AT E R I A L S R E Q U I R E D The following is a list of tools and materials that should be available for proper installation. Phillips screwdriver set Slotted screwdriver set Torx drive screwdriver set 4' (1.2 m) of 1/4" copper tubing and saddle valve for the water ...

Make sure that the actual equipment that was shipped to you matches the design you are expecting to install. The Sub-Zero Built-In line offers the following design alternatives— framed, overlay and stainless steel models. Each of these design options has specific installation requirements, which means it is vital t ...

millimeters unless otherwise specified. 36" (914) 73" (1854) 36" (914) 73" (1854) 36" (914) 24" (610) 73" (1854) 723/4" (1848) ROUGH OPENING HEIGHT TO FINISHED FLOORING 723/4" (1848) MINIMUM HEIGHT REQUIRED TO FINISHED FLOORING (LEVELERS IN) 24" (610) ROUGH OPENING DEPTH 11" (279) 3" (76) 24" (610) W LOCATE WATER SUPPLY WIT ...

30" (762) 84" (2134) 36" (914) 84" (2134) 30" (762) 84" (2134) 36" (914) 24" (610) 84" (2134) 833/4" (2127) ROUGH OPENING HEIGHT TO FINISHED FLOORING WITH STANDARD 11" (279) GRILLE 83" (2108) MIN HEIGHT REQUIRED TO FINISHED FLOORING (LEVELERS IN) 751/2" (1918) 7" (178) 6" (152) A ROUGH OPENING WIDT ...

millimeters unless otherwise specified. 36" (914) 42" (1067) 48" (1219) 42" (1067) 48" (1219) 24" (610) 84" (2134) 833/4" (2127) ROUGH OPENING HEIGHT TO FINISHED FLOORING WITH STANDARD 11" (279) GRILLE 83" (2108) MIN HEIGHT REQUIRED TO FINISHED FLOORING (LEVELERS IN) 751/2" (1918) 7" (178) 6" (152) A ROUGH OPENING WIDTH 24" ...

millimeters unless otherwise specified. 8 ELECTRICAL R E Q U I R E M E N T S A 115 V AC, 60 Hz, 15 amp circuit breaker and electrical supply are required. A separate circuit, servicing only this appliance, is required. All Sub-Zero Built-In models are equipped with a power supply cord with a 3-prong grounding plug, which must ...

Uncrate the unit, remove its wood base and discard the shipping bolts that hold the wood base to the bottom of the unit. Remove all packing materials and tape. IMPORTANT NOTE: Do not discard the kickplate, anti-tip blocking kit and hardware. These items will be needed for installation. Retract the front leveling legs to allow you to mo ...

Shut off power to the wall outlet. Plug the power supply cord into the 15 amp grounded outlet and roll the unit into position under the wood block or soffit. Using the front and rear leveling legs, raise the unit until it makes contact with the wood block. See Level the Unit, page 11. IMPORTANT NOTE: If possible, keep door(s) closed o ...