Homelite 18775 Assembly Instructions

FOR BACKPACK BLOWERS DISCONNECT SPARK PLUG BEFORE PERFORMING MAINTENANCE, ADJUSTMENT, LUBRICATION AND STORAGE. The new handle and switch kit consists of (1) right control handle, (1) left control handle, (1) electrical leads with termi- nals and throttle cable and (1) switch. Steps for removal of old handle and switch are as follows: 1. Remove frame from volute housing. 2. Remove shroud, outer volute housing, blower fan, and inner volute housing. 3. Disconnect old electric leads. NOTE: Lead from new handle and switch will be con- nected in same manner as old (Example: white lead to ignition module and black lead to ground). 4. Remove throttle cable from carburetor. Disassemble handle assembly. Discard old handle, switch, and electric lead and terminals. IMPORTANT Do not discard trigger, throttle latch, (2) plastite screws, bolt and wing nut. These parts will be used to assemble new handle and switch. Refer to illustration before assembly of kit. Assemble kit using trigger, throttle latch, throttle cable, screws, bolt and wing nut from old handle assembly. Connect white electrical lead to the ignition module and the black lead to ground. Attach throttle cable to carburetor. Reinstall inner volute housing, blower fan, outer volute housing, shroud and frame. SWITCH (02497) ELECTRICAL LEAD with TERMINALS and THROTTLE CABLE (PA00666) CONTROL HANDLE- Left (03923) CONTROL HANDLE- Right (03922)