Hoover F7441 Manual 

the following: WARNING: To reduce the risk of fire, electric shock, or injury: • Use indoors only. • Use only on surfaces moistened by the cleaning process. Do not immerse product. • Connect to a properly grounded outlet only. See “Grounding Instructions”. • Do not clean over floor electrical outlets. • Do not use without tanks in place. • Do not fill with water above 140˚F (60˚C). • Use extra care when cleaning on stairs. Do not place deep cleaner on stairs. • Use deep ...

3-23 Ne pas effectuer plus de deux passages humides ou rinçages sur une même zone afin d’éviter de saturer le tissu et de l’endommager. Si un nettoyage supplémentaire est nécessaire, attendre que le tissu soit complètement sec avant d’utiliser l’accessoire de nouveau. 13. Vider le réservoir de recouvrement lorsque le bruit du moteur devient nettement plus aigu et qu’il y a perte de succion (voir la section « Arrêt automatique » à la figure 2-6). Lorsque le nettoyage est terminé, suivre les instructions de la section « Après le nettoyage » aux ...

handle. Slide caddy down so notch (G) on caddy rests in hook (H) on cleaner. Storing hose and tools Press hose, a few inches from nozzle connector end (I), into caddy. Bring hose up and over top of caddy. Press hose into opposite side of caddy. Loop hose at bottom of cleaner and press into top of hook (K). Loop hose over top of caddy again. Slide hose clip (L) toward end of hose. Snap tab (M) on hose connector into hose clip. Insert top of bare floor tool (available at additional cost if not included with your clea ...

Press down on nozzle to secure it. Replace recovery tank (Fig. 2-17). The nozzle must be in the proper position in order for the recovery tank to go on properly. Raise cleaner to upright position and replace clean water tank (Fig. 2-15). 3-6 3-7 ON OFF WASH AUTO RINSE Rinse 3-8 Read “Before you begin cleaning” instructions on page 9. 1. Fill clean water tank according to instructions for Figs. 2-9 to 2-12. 2. Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-13 to 2- ...

The assembled deep cleaner will look like the drawing. Model with SpinScrub™ hand tool is shown. 2-1 2-2 1. Hand grip 2. Solution trigger: press to release cleaning solution 3. ON/OFF switch 4. Rinse Setting switch 5. SpinScrub™hand tool (not included with all models) 6. Carrying handle 7. Clean water tank handle 8. Clean water tank 9. Detergent container 10. Recovery tank handle 11. Recovery tank: holds dirty solution 12. Recovery tank latches 13. Brush setting selector 14. Solution tube connection port 15. Nozzle 16. Hose connection port 17. Cord hook: rotates for quick c ...