Hoover Convertible U4059 Owner's Manual

Unscrewnut and remove bolt and plate from handle socket. Place handle so that the holes in the bottom of the handle are directly in line with the electrical prongs and make sure the handle is positioned so that the switch is to rear of cleaner. Push down until handle is securely in place. Insert bolt through small holes of handle pieces and secure with nut. Tighten nut with screwdriver. If bolt appears too short, the plate is on backwards or upside down. Make sure that the contour of the plate fits around the handle as in illustration. ATTACH OUTER JACKET TO CLEANER Pl ...

jacket for long, trouble- free life. When extra length is needed for clean- ing bare fl ...

attachments plus the tele- scoping wand can be packed inside. For ease in storage, it can be hung on the cord hook of the cleaner. (The kit has two slots located near the top for ease in hanging.) Also it can be hung conveniently on a hook in the closet. CARING FOR THE CLEANING TOOL ATTACHMENTS To clean the hose wipe off dirt with a cloth dampened with a liquid detergent. Use a damp cloth to remove detergent. The attach- ments may be washed in warm water and detergent. Rinse and let dry before using. NOTE: Disco ...

end of the agitator roll there is a raised metal plate. Makesure that this end is placedin grooveon side of cleaner. 6. Place belt on pulley. Side of belt nearestcleaner should be in line with arrow on bottom of cleaner. 7. Replacemetal plate. Place metal knobs on front end of plate in wire holders. Check to see that latches are pushed back and will not be covered by plate. Place plate in posi- tion and latch securely. 12 ...

be Sure the belt is in good condition. If it is stretched or cut, it should be replaced. HOW TO REPLACE THE BELT 1. Disconnect cleaner from electrical outlet before re- placing belt. 2. Turn cleaner over. Re- move metal plate on hot- tom of cleaner by pushing latches toward outside of cleaner. 3. Release worn belt from pulley. 4. Lift out rug agitator, remove old belt and place new belt in groove of rug agitator. 11 ...

Unscrewnut and remove bolt and plate from handle socket. Place handle so that the holes in the bottom of the handle are directly in line with the electrical prongs and make sure the handle is positioned so that the switch is to rear of cleaner. Push down until handle is securely in place. Insert bolt through small holes of handle pieces and secure with nut. Tighten nut with screwdriver. If bolt appears too short, the plate is on backwards or upside down. Make sure that the contour of the plate fits around the handle as in illustration. ATTACH OUTER JACKET TO CLEANER Pl ...

end of the agitator roll there is a raised metal plate. Makesure that this end is placedin grooveon side of cleaner. 6. Place belt on pulley. Side of belt nearestcleaner should be in line with arrow on bottom of cleaner. 7. Replacemetal plate. Place metal knobs on front end of plate in wire holders. Check to see that latches are pushed back and will not be covered by plate. Place plate in posi- tion and latch securely. 12 ...